Question about Chevrolet Impala

1 Answer

My a/c blower intermittently stops working in all settings. It has a new blower which was installed one month ago. Vent, recirculate and a/c lights will come on when pushed and the compressor will run but no blower.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 6,918 Answers

The blower might be at fault,bump the blower motor,sometimes they will start working if the blower motor is bad,but not always,make sure it is getting voltage to the blower motor,if it is,replace the blower motor.If this was at all helpful,please rate,thank you.

Posted on Aug 21, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Air only blows out defrost vents VERY LITTLE


There is a cabin air filter in the unit. The filter is behind the glove box. It slides out.

Mar 03, 2014 | Buick Cars & Trucks

1 Answer

2008 vw jetta makes noise from blower


OK. The noise you are hearing is the recirculation flap motor. It could be what is causing the condensation. Easy way to check in after the noise has stopped push the recirculation button on the AC controls to see if the noise happens. If the motor is bad and the flap isn't closing you could be getting moisture from the outside air. As far as the check engine light goes there is no relation. 2 completely different systems. The flap motor would probably run you a couple hundred of dollars. The check engine light could be anything.

Dec 14, 2013 | 2000 Volkswagen Beetle

2 Answers

2004 Chrysler Pacifica a/c doesn't blow any air in front vents, only defrost works


I have the same problem starting on mine. The first answer above is totally wrong. The actuators that control the doors are 12 volt electric no vacuum. There are three actuators on the drivers side under the panel by the gas pedal. I haven't worked on mine so I can't tell you which one it is but all are the same part and interchangeable take a new one and try it in each position until it works.There is one in the center console and one under the passenger side by the blower motor the console is for rear HVAC and the passenger one is for recirculation after installation it will have to be calibrated . Turn ignition to ON not start push the power button and the recirculation button at the same time hold for 5 seconds lights should start flashing leave it for two minutes or the lights stop flashing. If they don't stop recalibrate until they do. If they won't stop drive for eight miles and it will stop on it own. (but not fixed)

f1f15143-ce6f-44d3-a264-570a62bf03a4.gif


2004-chrysler-pacifica-c-doesn-39-t-bq0jz3zw1zvhvds4ql4jkgei-4-2.gif


2004-chrysler-pacifica-c-doesn-39-t-bq0jz3zw1zvhvds4ql4jkgei-4-3.gif

Jul 09, 2012 | 2004 Chrysler Pacifica

1 Answer

1990 Buick Park Avenue heat works intermittently


check connector at blower motor, common problem there.

Dec 12, 2009 | 1990 Buick Electra

1 Answer

My recirculation button light turns on, does not blow out hard air anymore though. just stopped about 5 months ago.


The recirculation door is most likey stuck. You should be able to see the door if you take the cowl and wirers off. If it's stuck the actuator or the door is binding. Hope for the actuator not the door. If the door stuck then you have to remove the dash

Sep 16, 2009 | Chevrolet Silverado 1500 Cars & Trucks

2 Answers

Vent


Get a new blower motor and relay.

Apr 28, 2009 | 2004 Isuzu Rodeo

1 Answer

My blower only works on setting 123 + air con not that cold


You have a resistor array assembly going out. What you described is typical of the first resistor going out and over loading the second, which goes out and overloads the third. Replace the HVAC resistor array. Don't buy a used one. Spend the extra money on the new OEM dealer item. Good luck to you.

Apr 20, 2009 | 2000 Jeep Cherokee

1 Answer

Recirculation light and ac light flash when you push them


when it is cold out your car is designed to make sure it is not on recirculation mode if it was your inside windows would be all fogged up because of humitity .

Jan 30, 2009 | 2007 Chevrolet Equinox LS New Cars

1 Answer

2000 grand am se blower


It could be the actual switch maybe???

May 05, 2017 | 2000 Pontiac Grand Am GT

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

315 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6910 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...