Question about 2000 Nissan Frontier

Open Question

How to replace oil pump in 2000 nissan frontier

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 14585 Answers

SOURCE: 2000 nissan frontier knock sensor code & distributor

no but the knock sensor does send a signal the ecm and it will ****** or advance the distributor timing

Posted on Jun 14, 2010

  • 10 Answers

SOURCE: Nissan Frontier torsion bar replacement

well it depends how you want to adjust it, if you want to lower it, back out the screw on the torsion key a couple of turns. raise, screw it in a couple of turns

Posted on May 29, 2008

  • 2 Answers

SOURCE: 2000 Nissan Frontier replace headlight

there is a holder for the head lights you have to unscrew this holder from the outside on the front of the truck unhook the plug on rear of head light then reverse the process to reinstal good luck

Posted on Jan 16, 2009

  • 2 Answers

SOURCE: change brake light bulb on a 2000 Nissan Frontier

The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.

Posted on May 04, 2010

  • 14585 Answers

SOURCE: My 2000 Nissan Frontier has sputtering problems

your tach is run by the engine computer, possible cause. also by the crankshaft position sensor, most likely cause, I would start there. some sensors will run within perimeters and be bad enough to cause a lot of problems

Posted on Jun 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel pump located on a 2000 Nissan frontier desert runner v6


pump is in the fuel tank and is part of the sending unit assembly(replaceable seperately). i was told this by a nissan dealer when my nissan was getting the sending unit recall done about a month ago. i asked them if since the sending unit was going to be new if it included a new pump, they said no, its replaceable seperately but it goes in the sending unit assembly.

Mar 04, 2011 | 2000 Nissan Frontier

2 Answers

What are the signs and symptoms of a fuel pump needing replaced. Other than the obvious that the car will not start 2000 Nissan frontier V6, 3.3L 4x4 crew cab


You don't hear it running when your turn the key on just before the crank position.

You have replaced the fuel filter and it was pretty much stopped up. (destroyed pump trying to pump through stopped up filter.)

Because it was going bad you couldn't drive fast because it wasn't pumping enough fuel.

Disconnect fuel line and see if fuel comes out when you turn the key on.

Dec 23, 2010 | 2000 Nissan Frontier

1 Answer

How to replace oilpump in 2003 nissan frontier. 4 zyl. 4by4 manual shift


hey hit me back in the comments if picts don't load 4L Engine 7924vg43.gif

Align the punch mark with the oil hole before oil pump installation-2.4L engine
Click to Enlarge 7924vg44.gif

Oil pump exploded view-2.4L engine
Click to Enlarge

  1. Before servicing the vehicle, refer to the Precautions Section.

  2. Set the engine to Top Dead Center (TDC) of the compression stroke for the No. 1 cylinder.

  3. Remove or disconnect the following:

    • Distributor cap

    • Distributor

    • Engine under cover

    • Stabilizer bar

    • Oil pump and drive spindle

To install:

  1. Fill the pump housing with engine oil, then align the punch mark on the spindle with the hole in the oil pump as shown.

  2. Install or connect the following:

    • Oil pump and drive spindle. Tighten the mounting bolts to 96-132 inch lbs. (11-15 Nm).reverse procedure on other componets Start the engine and check for leaks.Check the ignition timing and adjust, as necessary.

Dec 12, 2010 | 2000 Nissan Frontier

1 Answer

I need to remove fuel pump from 2000 nissan frontier


the fuel pump is located in the gas tank.

May 19, 2010 | 2000 Nissan Frontier

1 Answer

1999 Frontier: nissan frontier 2000 automatique tansmision revers...


Either transmission oil pump is on its way out or reverse circuit is clogged , reverse shift solenoid is defective TCM may be defective , transmission range sensor begining to fail or manual shift valve and pressure regulator are defective.

Suggest taking the vehicle to a transmission repair shop they will diagnosis it and repair it.

May 18, 2010 | 1999 Nissan Frontier

2 Answers

What is eng oil capacity for a nissan frontier 4 banger 2000 model


Including filter; the oil capacity for a 2WD, 2000, Nissan, Frontier, 4cyl (Ka24de) is 3-3/4 quarts. Straight out of the Haynes manual.

Nov 28, 2009 | 2000 Nissan Frontier

Not finding what you are looking for?
2000 Nissan Frontier Logo

Related Topics:

332 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...