Question about 2000 Mercury Cougar

1 Answer

Can i drive with out air comprresor? - 2000 Mercury Cougar

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,092 Answers

As long as the belt pulley on the compr. is not lock up, start engine and look at belt, if it spins freely and not making any kind of noise, then your ok, but if it is, you will need to by-pass a/c compr with shorter belt.Hope this was very helpful.

Posted on Aug 20, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Heater temp on high only bows luke warm air after driving. A/C works just fine.Plenty of cold air from it


heater blows cold air idle chrysler 300 Questions & Answers ...

www.fixya.com > Forum > Tags
Find solutions to your heater blows cold air idle chrysler 300 question. ... blow warmair for a few mins then back to luke warm. i replaced thermostat ... HEAT BLOWSCOLD AIR WHEN IDLING ONLY GETS HOT WHEN START DRIVING ... About 15 minutes after driving the diver side vents start blowing straight cold air but the ...

Heater only works when pressing the gas? - DoItYourself.com ...

www.doityourself.com/...repairs.../459521-heater-only-works-when-pres...
Nov 3, 2011 - When I press the gas, the air from the vents is nice and hot. .... So am Idriving a car with a ton of problems, or could the power steering ... Just anotherquestion, when warmed up does the engine temperature ... When the heater is on and I'm not pressing the gas pedal, luke warm air blows from the vents.

Heater blows cool air when stopped and warm air while ...

https://www.reddit.com/.../heater_blows_cool_air_when_stopped_...

RedditFeb 12, 2014 - Heater blows cool air when stopped and warm air while driving 2008 Kia Spectra (self. ... just fine but appears to blow cool air when I was stopped at a stoplight. ... My temp gauge would also be pegged high when at idle / low RPM. ...thermostat only blocks coolant going to the radiator, and the heater core, ...Missing: 300m ‎luke

Why is My Car AC Blowing Hot Air? - BlueDevil Products

gobdp.com/blog/car-ac-blowing-hot-air/

Jan 27, 2016 | 2000 Chrysler 300M

1 Answer

Why my 06 suzuki reno blow air while idling but blow hot air when put in drive


is this a HVAC question heater and a/C?
cold engines, make only cold air
hot engines make hot air.
for 100 +years. now.

Mar 26, 2015 | 2006 Suzuki Reno

1 Answer

My air fluctuates. When I'm idling its warmer than when I'm driving. While I'm driving the air drops to 43 to 45 degrees. While idling it climbs to 65to70 degrees. What might cause this problem on a 95...


Normal, its called air flow. When idling you rely on the radiator fan only, when driving the air is rammed through the radiator. as long as it doesn't clime into the red at about 90' when idleing you are OK.

May 21, 2014 | Cars & Trucks

1 Answer

P0101


P0101: MAF or VAF A Circuit Range/Perf

- Dirty mass air flow sensor
- Dirty mass air filter
- Mass air flow sensor harness is open or shorted
- Mass air flow sensor electrical circuit poor connection
- Intake air leaks
- Faulty mass air flow sensor

Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.

Feb 09, 2012 | 1999 Pontiac Grand Prix

1 Answer

Overheating when on highway or using air conditioner


The condenser for the ac is not getting enough air,look for the reason,look in front of the car at the radiator,see if there is something restricting air flow threw the radiator and condenser.

Jul 11, 2010 | 1996 Mercury Sable

1 Answer

Am trying to charge my ac but my ac switch keep blinking and the comprresor dont kick in


You can make your compressor come on manually by putting a jumper
in the wiring connector going to the evaporator. It's the 2 wire plug.
If you foolw the wiring from the compressor,you should be able to
figure out where the wiring is. Just remove the plug and put a jumper wire across the terminals to get the compressor clutch to engage and
make the compressor pump.Good luck.

Mar 28, 2010 | 2002 Toyota Camry

1 Answer

04 gmc yukon heater air cold passanger side.


If this happens when you are idle, and then you get hot air as you drive, most likely you have low coolant and it only cycles as you drive. Get approved dextrom gmc coolat and cap off your coolant it is most likely low.

Jan 17, 2010 | 2003 GMC Yukon XL

1 Answer

I need to replace the drive belt on my 98 Ford Escort ZX2 manual transmission and need a diagram and to know where the tensioner is located. It is a single belt.


There are 3 possbile diagrams, depending on whether it's equipped with AC and engine type. The 3 are listed below. Thank you for using Fixya and please remember to return to rate this answer.
Greg

98 Escort Drive Belt Air #1
289d121.jpg


98 Escort Drive Belt Air #2
91346f7.jpg

98 Escort Drive Belt no Air
30a8765.jpg

Dec 20, 2009 | 1998 Ford Escort

1 Answer

Need diagram for serpentine belt


2004 SUZUKI FORENZA - L4 2.0L 2000cc GAS FI N

Adjustment

The belt is automatically adjusted by the auto tensioner.


Drive Belt Routings

47cc840.jpg

Fig. Accessory drive belt routing-2.0L engine



Removal & Installation
  1. Remove the air filter housing assembly bolts and the air intake tube.
  2. Remove the air filter housing assembly from the vehicle.
  3. Use a wrench to turn the tensioner bolt clockwise, compressing the tensioner, and releasing the tension on the serpentine accessory drive belt.
  4. Remove the serpentine accessory drive belt.
To install:
  1. Use a wrench to turn the tensioner bolt clockwise, compressing the tensioner, and releasing the tension on the serpentine accessory drive belt.
  2. With the wrench in place on the tensioner bolt, loop the serpentine accessory drive belt loosely over the pulleys.
  3. Slip the belt over the tensioner.
  4. Remove the wrench from the tensioner bolt and the belt will tighten itself.
  5. Install the air filter housing assembly into the vehicle.
  6. Install the air intake tube and the air filter housing assembly bolts.
  7. Tighten the air filter housing assembly bolts to 53 inch lbs. and nm
I really hope helped with this. remember rated this help. Good luck.


Nov 12, 2009 | 2004 Suzuki Forenza

1 Answer

A/c problem


ok when ur sitting there no hot air is coming in to the air con radiator at front of car because your not driving
but when your driving it comes in but stays cold because the fan kicks in is your aircon fan working?

or does it need more gas thats what else can cause this

Sep 09, 2008 | 2001 Plymouth Neon

Not finding what you are looking for?
2000 Mercury Cougar Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

fordexpert

Level 3 Expert

5470 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...