Question about 1993 Isuzu Rodeo

3 Answers

Everything has power when i turn the key to the on position but when i turn the key to start the truck, nothing happens. headlights dont dim or anything and everything still has power. all fuses are good. I have put 2 new starters on it and neither starter fixed the problem. Put a new neutral safety switch and a new ignition switch on it and it still wont crank or move at all. It starts no problem when i push it and kick start it. 1993 isuzu rodeo, V6, 4 wheel drive, 202K miles, standard transmission

Posted by on

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Guru:

    An expert who has written 7 tips or uploaded 3 video tips

  • Master
  • 642 Answers

Have a look at this:
http://www.fixya.com/cars/r5605161-trouble_shooting_isuzu_starter

Posted on Aug 26, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 462 Answers

Check if you getting power to the single wire on the starter when you turn key to start position.If power is not there then starter is not a problem , I'm not sure if this car has a starter relay , but you may want to check that too.

Posted on Aug 20, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 560 Answers

When you crank the engine are you getting a full 12 volts positive at the solenoid switch on the top of the starter?

Have you got a full 12 volts negative to the switch?

Also, check the earthing strap from chassis to engine is good.

Regards

Lloyd

Posted on Aug 20, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

It wont star light working key turn but new battery but nothing happen ford ranger 2001 check just everything I cold think


if you turn your headlights on and its getting down to the starter your headlights should dim while turning key.

Dec 14, 2015 | 2001 Ford Ranger

2 Answers

Turn key lost all power


Clean and tighten battery cable connections and check battery ground, engine ground-should be a ground strap from engine to the body or frame. If this happens and you have nothing, no headlights, nothing-it's almost certainly a problem at or right off the battery.

Dec 26, 2013 | 1986 Ford Ranger 2WD

1 Answer

When i turn the key, to start nothing happens. The headlights work and dont dim when when key is turned to start. Also the key has been hard to turn


Adaa, check your ignition fuse first. It should be labeled. Replace it and try to start it. If it doesn't work, write me back. I will help you through this if you want to.

Feb 25, 2011 | 2002 Nissan Sentra

1 Answer

Engine doesnt respond to key


Welcome to Fixya

You may want to check first if you have a fully charged or good battery. You may honk your horn or test the headlight. If battery is ok then you might need to test the ignition system. Turn on your headlights and try to turn the key to start position. Your headlight should go dim. If nothing happens then the problem is the ignition assembly.

Thank you for using Fixya!

Jan 09, 2011 | Chrysler Voyager Cars & Trucks

2 Answers

My bonneville will not crank you turn the key nothing happens letgo on the key and the gages do a rest and still nothing happens. we will try locking and unlocking to to reset alarm . after some time it...


anti theft if you don't have a codeable radio reset your computer by disconnecting positive cable on battery for 5mins if that does'nt work turn headlights on @ turn key if lights dim probable bad starter

Aug 15, 2010 | 2001 Pontiac Bonneville

1 Answer

2002 Dodge Intrepid accessory/starter relay problem?


Accessory position is turning key towards he driver. Ignition on is away 1 and start is away2.
  • Turn on your headlights, do they work? If not, chk batt terminals
  • If they do, try to crank the engine noting what the headlights do. If they go out, Chk the batt ground cable. If they dim, your batt needs a charge. If they dim and then come back bright when you back off the starter, the starter is bad.
  • Chk for loose engine to body ground. That would affect the accessories. Good Luck, _Ned_

Oct 18, 2009 | 2002 Dodge Intrepid

1 Answer

My 99 Expedition just died while driving. After towing it home it now wont even turn over. I can jump the starter and it engages and I have power to dome light and headlights but when I turn key nothing (...


I has an 86 Mustang that did a similar thing and it turned out that the battery actually shorted out. This happens when one of the plates inside the battery brakes off and then touches another plate. When mine died it was like I turned the iginition off. It wouldn't turn over even with jumper cables.

Oct 18, 2009 | 1999 Ford Expedition

1 Answer

Chevy tahoe won't turnover, power to everything, no clicking in starter to indicate that it is the starter, nothing happens when you turn the key? any sugg My problem is similar. My 2003 4wd will start...


Next time it won't start turn headlights on and see if they dim when you turn key to start, if they dim its most likely starter, if they don't dim possible starter switch, Have you tried to start it in neutral position? Try that, if it starts in neutral than its park neutral switch, if not could be starter switch, Just make sure you chk. all fuses and any relays associated with ignition first.

Feb 15, 2009 | 2003 Chevrolet Tahoe

1 Answer

Car wont start


It may be to alternator...very expensive to fix...

Dec 13, 2008 | 1994 Buick Century

Not finding what you are looking for?
1993 Isuzu Rodeo Logo

469 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...