Question about 1994 Mazda 323

1 Answer

94 mazda familier. Iv got the alternator off, how do i get it out to replace ? There is no room anywhere for it to come out. Do i have to take the motor out ?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 395 Answers

There should be just enough room to juggle it out from under the car. If the gap is slightly small, try using a lever to move the engine a bit to enlarge the gap.

Posted on Aug 20, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

!993 Mazda Miata. First she asked me to give her a jump start she thought she left something on. I boosted her and told her to drive for about a half hour before shutting off car. An hour later she said it...


When you turn the ignition switch to the start position
on any vehicle, there is no dash lights or anything,that is
how it works

Test the ignition switch & the starter & starter relay

Sep 05, 2013 | 1995 Mazda MX-5

1 Answer

Why does my room fuse keep blowing


Now you have a big Short, will be a good ide to Run the scanner/computer and fix it. Do not waste time+money. Remember the electronic vehicle is complicated now.
see the diagram attached.fb2b20d0-ca04-4fbe-a0f3-cba7c3144854.jpg

Jul 27, 2013 | 2000 Mazda 626

1 Answer

The engine turns over but not starting the cambelt is good. iv tried puting plugs in the hose but stil wont work help! (v6 manual lantis 94)


what do you mean putting plugs in the hose?
are you getting spark?
have you replaced the cam timing belt?
if so did you line all timing marks up?

Jan 13, 2011 | Mazda 323 Cars & Trucks

1 Answer

Mazda Miata 94 Clutch goes to the floor Fluids are fine Worked fine yesterday Any ideas


you need a new clutch system cost anywhere from 50.00 to 300.00 hundred bucks

Jan 12, 2010 | 1988 Honda Prelude

1 Answer

My 94 Mazda MX-6 has no fire. Have replaced the


Further test showed that the Crank Position Sensor was bad. Replaced it and the vehicle was fine.

Jan 09, 2010 | 1994 Mazda MX-6

1 Answer

How to change a fan belt on a 323 mazda 1997


Loosen alternator right back You will have to loosen pivot bolt underneath alternator Replace belt and tighten alternator until you can move belt about 5-6mm by pushing on it with two fingers Quite fiddly job Not much room

Oct 25, 2009 | Mazda 323 Cars & Trucks

1 Answer

3rd dead battery in 6 months


It's more likely a short circuit somewhere or a sticky door switch. Battery cables can be corroded but not normally bad in that they don't transfer current. Assuming the connections are tight and clean, the problem is probably elsewhere.

Sep 05, 2009 | 2002 Mazda Protege

Not finding what you are looking for?
1994 Mazda 323 Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8589 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...