Question about 1997 Jeep Wrangler

Open Question

What is fuse F5 under the hood of a 1997 Jeep Wrangler used for? The engine turns over and is getting gas. F5 was blown, replaced F5 (20amp) and it did not blow again.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: 1997 Jeep wrangler

take it to a mechanic if you air bag is messing up you should have it fixed immediatly

Posted on Aug 19, 2008

  • 9 Answers

SOURCE: locate the cabin air filter for a 97 jeep wrangler

No cabin filter in a 97 Jeep Wrangler.

Posted on Apr 15, 2009

herbalgarden
  • 344 Answers

SOURCE: '00 Jeep Wrangler with no heat and AC not blowing

Ok, if you are trying to use your AC and its not turning on, odds are your refrigerant levels are low, the system will not turn on when low fluid levels are present so the system doesnt burn up the compressor.

If your blower motor is not operating, you may have a fuse blown that needs to be replaced, or the control chip that plugs into the blower motor (for fan speed settings) has burned up (easy fix).

If your climate control is not throwing out heat when you change the settings to hot, you have a leaky vaccume line and the vaccume pressure is not strong enough to open or close (depending on setting) your blender box. Although typically when a vaccume line springs a leak you will have issues with your selector switch as well (defrost, vent, floor)

Also pay attention to your temp gauge to make sure the thermostat is operating properly, and the engine is not over heating ro getting excessivly hot! If it is, then you need to replace the thermostat ($8 part)
and go from there. Also you should check your heater core, if it gets clogged or has restricted coolant flow, your system wont have the heat it normally did (if any) when it worked properly.

This is just a quick summery of the area's you should be looking into for the problems you are having! thanks for using Fixya.com and good luck, I hope I have helped make resolving your problem alittle easier

Posted on Jan 08, 2010

Testimonial: "herbalgarden answered my question fully. No one-word answers here; he answered each aspect of the problem and offered multiple troubleshooting points"

ZJLimited
  • 17970 Answers

SOURCE: I need a diagram for the under hood fuse box. More

Are you sure that this is for 20AMP, according with the repair manual, the position 20 in the Power Distribution Center if for Power Motor ABS Pump, and is 10AMP.

Verify it..

Posted on Mar 17, 2010

  • 6982 Answers

SOURCE: how do i replace serpentine belt on 1997 jeep wrangler

Adjustment is made by loosening the power steering pump. There is a transverse long bolt (jack bolt) right under the pump that is used for adjustment.

Posted on Aug 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My power outlet beside cig lighter quit working I can't locate the fuse for it 2004 jeep wrangler.


both 20amp
F17 is in PDC(under hood)
F18 is in cab box. (answer assumes car starts and drives)
26223724-1nshu3pptitflaomei2asm0z-1-0.jpg

Jun 22, 2016 | Jeep Cars & Trucks

1 Answer

97 jeep wrangler 4.0 when ignition on the fuel pump runs all the time but the engine does not start.replaced the fuel pump but still does the same thing.ive got fire and good pressure at the rail but no...


my problem related to ASD (automatic shutdown relay) wiring not tight on terminals (fuse box under hood). I traced this to a mechanic (national chain) repeatedly kept dislodging the ASD wiring (while supposedly tracking down fuel pump problem). This act eventually caused the computer to fry.

Dec 27, 2012 | 1997 Jeep Wrangler

1 Answer

Which fuse for my jeep wrangler 97 is for the ciggarette lighter?


Hi, the 1997 Wrangler has two fuses to check. Both in the Power Distribution Center (PDC) under the hood. Fuse 3 supplies the accessory circuits through the ignition key and energizes the coil of the accessory relay. If your radio works that fuse is OK. The other fuse, fuse 5 supplies the power to the accessory socket when the relay is energized. The relay is behind the glove box and mounted to a stack of multi-wire connectors.
Replace fuse 3

Jul 26, 2011 | 1997 Jeep Wrangler

1 Answer

Both headlights out on 1997 Jeep Wrangler. Don't see a fuse in the box in the dashboard indicating headlamps. Looked in the engine compartment, but don't know which fuse to check.


There is a fuse box under the hood on the passenger side remove the cover and the #10 fuse is for the headlamps. Look on under side of cover for fuse #s.

May 19, 2011 | 1997 Jeep Wrangler

1 Answer

Lighter Fuse location


The fuse is a "Maxi Fuse", 20amp, located in the power distribution center under the hood. Black rectangular box close to the battery.

Jan 09, 2011 | 1998 Jeep Wrangler

1 Answer

I need to replace the cam sensor on my 97 jeep wrangler were do i find it in the motor..


For 1997 Jeep Wrangler 4WD 4.0L MFI 6cyl the Camshaft Position Sensor is located: Under hood, passenger side, front engine area, mounted on front of intake manifold

Hope helps (remember to rate this).

Oct 12, 2010 | 1997 Jeep Wrangler

1 Answer

I have a 1997 Jeep Wrangler with a 2.5L engine. It was running great but recently would not start. The engine turns over but acted as if not getting fuel. When I cleaned and pressed down on the fuel pump...


the connector under fuse panel that goes on the fuse is heat damaged from overload or loose tension [usually is loose tension] obvios signs are heat damaged plastic around the offending connector.could be the wire is broken right at the fuse. you will have to get at beneith the panel and check it out splice in NEW connector[s] as needed

May 08, 2010 | 1995 Jeep Wrangler

2 Answers

I need a diagram for the under hood fuse box. More importantly the specific 20 amp fuse labeled F21. What is it for. I have a 1998 jeep wrangler 4.0 4wd.


Are you sure that this is for 20AMP, according with the repair manual, the position 20 in the Power Distribution Center if for Power Motor ABS Pump, and is 10AMP.

Verify it..

Mar 17, 2010 | 1998 Jeep Wrangler

1 Answer

2000 wrangler interior console lights and rear lights not working


Check the Inside Fuse Box with a Flashlight for Blown Fuses. Then Check the Fuse Relay Box Under the Hood. Check the Fuses in that one to, If the Fuses are all good, Locate the Illumination, and Brake. Replace these Relays. That should get them back on, Let me know! Please Rate my Response, I need all the Help That I can Get! Thanks!

Jan 28, 2009 | 2000 Jeep Wrangler

1 Answer

Jeep wrangler Fuse box


You have two locations for the fuse box. One is either under the hood or behind the glove box. I would pull apart the glove box and take a look.

Jan 10, 2009 | 1997 Jeep Wrangler

Not finding what you are looking for?
1997 Jeep Wrangler Logo

Related Topics:

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...