Question about 2005 Jeep Wrangler

1 Answer

Po441 code jeep wrangler 05 - 2005 Jeep Wrangler

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Jeep Master
  • 3,640 Answers

P0441 meaning. emission system purge flow fault. The "EVAP purge flow" faults are issues between the carbon cannister and the intake.

Posted on Aug 19, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to reset the P2096 code error on my 05 Wrangler?

2095 ( a jeep factory code that is , jeep only)
reset. like all cars , you can reset any code, with any scan tool
but if the failure is real and present it will NOT.
that is its purpose to report real failures.
is this the 3.8Liter v6 , like mine is?
down means not the front sensor.
engine >>>>Up >>>>CAT >>>> down?>>>>> tail pipe end.
this is an air leak (crack) behind the cat converter
or the sensor is bad, (down stream.)
or wires fell off, (common) LOOK FIRST.see damage there?

Feb 16, 2015 | 2005 Jeep Wrangler

1 Answer

05 jeep wrangler wont start,has power to lights radio,battery good starer good.when you try to start inst.cluster does not come up.

check your engine block ground or the battery ground make sure the engine is properly grounded or is still grounded

Jun 19, 2012 | 2005 Jeep Wrangler

1 Answer

I have a 05 jeep wrangler the eng light is on comp says o2 senes b1 & b2 high voltage 250 km to a tank

If the oxygen sensors on the vehicle are faulty then that could easily cause the poor fuel economy. Replace both of the O2 sensors and clear the code with a scan tool. You should start getting better fuel economy. I hope this was helpful.

Feb 22, 2011 | 2005 Jeep Wrangler

3 Answers

Wrangler will not go into gear when the jeep is off

if transmission was good when engine is off you should be able to go through the gears. can also be stuck in between gears which you can fix by replacing worn shifter.

Jan 17, 2010 | 1989 Jeep Wrangler

1 Answer

E brake wire location in 05 jeep wrangler

The e-brake switch should be right on the pedal or lever. You may have to remove some trim to get to the wiring.

Nov 29, 2009 | 2005 Jeep Wrangler

2 Answers

2008 jeep wrangler throttle warning light on and the accelerator pedal is not functioning


Sep 15, 2009 | 2008 Jeep Wrangler

1 Answer

05 Jeep Wrangler High Beams Work, Low Beams dont

There are no relays for the headlights. Your problem could be from the headlight switch. You would have to check and see if you have power coming out of the switch on the low beam side. Check with a test light.

Dec 15, 2008 | 1997 Jeep Wrangler

1 Answer

Emergency brake won't release, 05 jeep wrangler

Hello smiversoon, My emergency brake did that too. I had it in for a clamp issue on my exhaust, and the person working on it said that it need replaced, by my honey, he said to just disconnected, I did use it anyways. So if you don't use yours just disconnect or have a new cable installed. Why it won't release I have no answer. But a good Jeep mechanic can tell you. Or if you put on Google search 05 jeep wrangler emergency brake won't release, hit search, I am sure others have similar story and a answer is not far away. Good Luck. Happy Jeepin'

Jul 01, 2008 | 1995 Jeep Grand Cherokee

1 Answer

Coolant flush

Go to web , , find your zip code area shops and call them. Listen to what they offer as a warranty if they do their thing, i believe you will be impressed. Its well worth it above the pain in doing the job yourself. I just had my '05 dodge done by BG.

Jun 11, 2008 | 2003 Jeep Wrangler

Not finding what you are looking for?
2005 Jeep Wrangler Logo

538 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides