Question about 1987 Chevrolet S-10 Pickup

1 Answer

Need to repalce gas line - 1987 Chevrolet S-10 Pickup

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,627 Answers

I don't know what part of the fuel line but it can all be replaced with 5/16 rubber line and hose clamps,the quick connect fittings can also be purchased at a parts store and they have barbs on them so that you can attach the steel line with rubber line.Then you can put things back in place with plastic ties.

Posted on Aug 19, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to repalce a fuel filter on a 1997 buick lesabre

The fuel filter should be in the fuel line between the gas tank and the engine. The line runs under the floor of the car.
You'll need a pair of pliers and a couple of wrenches.
One end of the filter uses a crimp clip to hold it in the line, the other end is a threaded pipe fitting.
Be sure to release the fuel pressure in the line before you take the filter loose.

Dec 24, 2012 | Cars & Trucks


Automotive Vacumn Line boots and 90s repalcement

You know all those vacumn-line-boots and 90(s) that always crumble and break before the rest of the line; and going to a parts store?, good luck..
Here's your solution; old sparkplug- wire boots are great replacements, they are thick enough to withstand the vacumn and the silicones used in them are heat-resistent enough.
Give one it a try, save money and gas on something very few part stores even stock to begin with.
Also will work on most any auto with a little knowhow too........

on Dec 07, 2009 | Chevrolet 1500 Cars & Trucks

1 Answer

Cannot turn off skidoo skandic with key or kill switch

check to see if both of those switches are actually plugged into the harness.

Jul 16, 2017 | Cars & Trucks

1 Answer

Brake fluid leak is seen at the rear driver side near gas tank how do I repalce this line?

I would strongly suggest that unless you have a brake flair kit,and know how to bleed brake lines you leave this job to a mechanic.This is not the kind of job a novice should be tinkering with,unless you have an experienced friend that can help you.A brake job that is not done properly can be life threatening.Please take my advice on this ,it may not be what you want to hear but it is the truth.Good Luck

Nov 06, 2010 | 1989 Mercury Topaz

1 Answer

Replace fuel pump 2002cheverlot suburban

Best way is to drop the fuel tank down. If there is fuel in the tank you would be advised to use a floor jack to help hold it in place. If you drop it without a jack you stand the risk of ripping out the fuel lines which could make the project a lot more difficult. Having dropped the tank and lowering it safely, you will first have to disconnect the fuel lines from the pump. After the lines are all disconnected there is a ring holding it in the tank. On the ring will be a few tabs that you will use a flat head screwdriver and a hammer to tap them around until the fuel pump can be pulled out of the gas tank.

Jul 18, 2010 | 2002 Chevrolet Suburban

1 Answer

A/c switch under dash how to check or fix

mcdevito75 here, No way to chek or test this A/C switch as it is right in line with the flow of freon gas. A/C must be drained before repalceing this switch.

Jun 18, 2010 | 2000 Jeep Cherokee

2 Answers

Gas leak

If the truck is running fine ,I would lean more towards your fuel tank it may have rusted out on you.

Sep 08, 2009 | 1995 Toyota 4Runner

2 Answers

What is the best way to access the fuel pump to repalce it without adding expenses? They want to cut the floor and do it. Will this cause problems in the winter? We live in Michigan with a lot of deep...

Too bad GM doesnt provide a cover to access tank without dropping the tank. I would think creating this "hole" would be quite the endeavor and done correctly would add quite the additional time and expense. Decline cutting holes and drop the tank in order to service the pump/sender. Any reputable repair firm should or would never recomend this measure in order to access the pump in the fuel tank I would hope....

Jul 10, 2009 | 1997 GMC Jimmy

2 Answers

Fuel filter

fuel filters are usually located under the driver side of the car. it will be a metal cylinder with 2 lines on it. one going to the engine and one coming from the gas tank.

Aug 02, 2008 | 2002 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides