Question about 2002 Mitsubishi Eclipse Spyder

1 Answer

On my '02 Spyder convertible the back passenger window will only go up and down two inches when its down and it will free flow upwards like there is no tension on it. Any support would be great. Thanks, Travis

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,382 Answers

Hi, you need to check out the window regulator motor which is actually in charge of the upward and downward movement of the window, it seems it's finding it difficult to go down either because it is stuck with something or probably the window regulator motor itself is faulty.

You need to open up the back passenger side window to see if there is anything disturbing the downward movement of the window and if there is nothing, then you definitely need to change the regulator motor because it is faulty...

Posted on Aug 19, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why won't my passenger window not close?


Too cold oitside and gravity little lower today

Jul 24, 2014 | 2007 Mitsubishi Eclipse Spyder GT...

1 Answer

Power window making noise, but window won't go up or down


Need to take off the door card (the soft lining on the door) and take a good look at the levers in the window mechanism, one has jumped out of position and may need replacing.

Dec 21, 2013 | 2008 Chrysler Sebring Convertible

1 Answer

Keys locked in trunk of 2007 eclipse spyder convertible


at trunk button override and jump switch if dont work have to make way to get through at back seat

Aug 05, 2012 | 2007 Mitsubishi Eclipse Spyder GT...

1 Answer

01 eclipse spider top and rear windows do not work


All three wire showing 3 it should be all 4 wires, In the back of the rear seat is the convertable top module, the yelloow black wire should go ground to bring it down.Other than that a new module will be needed,this gets its command from the window main switch so see if yellow/black wire switches over

Mar 17, 2012 | 2001 Mitsubishi Eclipse Spyder

1 Answer

02 Maserati Spyder - I was opening the convertible top when I decided to stop it in mid cycle and take a look at some sort or fluid leak on one of the hydraulics and I shut of the motor. Not smart because...


Man I'm sorry but these spyder tops are the most worthless thing I have seen. What a joke. Going to get mind fixed and get rid of this pc of **** car. What a joke.

Jun 12, 2010 | 2002 Maserati Spyder

1 Answer

I have 2008 toyoya tocoma truck only getting 13 mpg. the check engine light on, had it scope out said o2 sensor open, replced sensor had light cancel but came back on. still have problem


Are you sure you replaced the right 02 sensor? Some vehicles have up to 4 02 sensors and being the ones that have a seperated duel exhaust system. You will have an 02 sensor located upstream of the catalytic converter and one down stream of the converter so make sure you replaced the right on. If you used a scanner to tell you it was an 02 sensor it should have also told you bank one or bank two which translates to drivers side or passengers side will also tell you up stream or down stream.

Dec 01, 2009 | 2008 Toyota Tacoma

4 Answers

There is water leaking into compartment behind drivers seat


http://www.spyderchat.com/drainholes.htm
this will show pictures of what/ where to do. i had the same problem with my 2001 mr2 spyder. i tried clearing the drains along the sides of the top but i got better results after i took off the air intake vents along the side of the car and cleaned it from the bottom of the drain.

Nov 25, 2009 | 2003 Toyota MR2 Spyder

1 Answer

Need to reset the soft top on a maserati spyder


Manual roof procedure
The procedure in the manual is just for closing the top.
A) Turn key to OFF for several seconds to bleed off hyd pressure.
B) Turn key to MAR (full electrical, but before start)
C) Remove cap on bulkhead behind the right-hand seat and use flat head screw driver to unfasten the hyd unit valve in order to relieve the oil pressure in the circuit.
D) Remove the cap on the bulkhead behind the left-hand seat and using screwdriver or allen wrench press until the top covering (panel behind roll bars that covers the convertible top well) until the panel's locks are released - you may have to tap the wrench to release the locks.
E) Lift the top covering manually and keep it open while extracting the top from its well.
F) Remove top from well until the front part is near the windshield frame.
G) Lift the rear part of top (rear window) upwards and lower the top covering until the hooks are resting on their respective locks.
H) While still keeping rear part of convertible top lifted upward press Button 1 to attach the top covering locks.
Button 1 is the forward one
Button 2 is the rear one.
I) Make sure locks are fastened. if not - try pushbutton 1 again. If necessary repeat D and H
J) Rest rear part of convertible top on top of covering.
K) At front of convertible top, open (deploy) the top's hooks by using allen wrench to turn the pin mechanism. (located in center of front headliner)
L) Press top unto windshield frame and use wrench to lock the hooks.
M) Press the rear of convertible top, so hooks on rear top insert into respective slots and press Button 2 to secure.
N) Keep Button 2 pressed until hooks properly fasten.

If the top is still tightly latched at the front, you can just start at step "G":
While holding the back of the top in the air, and the "top cover" resting down on its "hooks", press button 1 until it seats well.
Then lower the back of the top down to mate its "hooks" and press it down while holding button 2 until the top seats well.

Sep 10, 2009 | 2002 Maserati Spyder

1 Answer

Location 02 sensor Bank1 sensor2 on 2001


in the exhaust , behind the catalytic converter.
autodoc

Jul 13, 2009 | 2001 Mitsubishi Eclipse Spyder

Not finding what you are looking for?
2002 Mitsubishi Eclipse Spyder Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...