Question about 1993 Jeep Grand Cherokee

Open Question

1993 jeep grand cherokee has no power to the coil

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 6982 Answers

SOURCE: 1993 JEEP GRAND CHEROKEE LAREDO IM TOTALLY BAFFLED

Back up a minute...Do you have spark from the coil wire? (juice from coil) If so, change or check rotor and cap (wires do not all go bad at same time so unless they are wet, likely at least good enough to start engine)

Posted on Mar 05, 2009

  • 6982 Answers

SOURCE: 1993 JEEP GRAND CHEROKEE LAREDO- TRUCK WONT

OK...I have a 93 outside...one diagram I have shows an ignition module next to coil...but there is none on mine, (4.0 engine)
Two items to check are crank sensor and cam sensor inside distributor. Test procedure can be found in just about any manual including haynes.
You will need a decent volt/ohm meter to do testing. You can also check codes by turning ignition switch on/off three times, leaving it on the third time. Check engine will flash code #'s (ex: one flash, pause two flashes= the number twelve.then followed by a longer pause then another set of flashes etc.)

Posted on Mar 05, 2009

polarcycle
  • 1392 Answers

SOURCE: 1993 Jeep Grand Cherokee Laredo wont drive when put into gear

No, not with out a lot of work. Electronics are most likely different on the 2 also.

Posted on Mar 11, 2009

  • 24 Answers

SOURCE: ignition coil keeps burning up.

The problem is somewhere else, clean everything up and inspect closely

Posted on Apr 29, 2009

  • 50 Answers

SOURCE: 1993 Jeep Grand Cherokee, V6. Oil Pressure Gauge Read High.

it could be the sensor you should look at the oil pressure relief valve

Posted on Jun 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changed coil in 1993 jeep grand cherokee lerado still not getting fire from coil


Have your ignition module checked. Also check codes for bad reference signal for cam or crank sensor.

Jul 29, 2012 | 1993 Jeep Grand Cherokee

1 Answer

1993 jeep grand cherokee put new sencor on, new fuel pump, new relay, coil pack and still is'nt getting any fire from coil. it just keeps cranking.


Crank position sensor mosly likey. Seems like you wasted a lot of money on unnessary parts. Crank sensor should cost about $40

Feb 24, 2010 | 1993 Jeep Grand Cherokee

1 Answer

1993 Jeep Grand Cherokee not getting power to coil


I don't work on Jeeps, but the Rangers have a power relay for the ignition. You might want to try asking at Autozone or O'reillys if the Jeep has any relays. It might be worthwhile to check the fuse panel to see if something blew that might control 2 or 3 things including the ignition. Hope this helps you.

Jul 19, 2009 | 1993 Jeep Grand Cherokee

1 Answer

1993 jeep cherokee. Can't get spark out of coil.


Check the Crankshaft Position sensor. Usually it will reveal itself through the check engine codes. If this is faulty, the coil will not get the signal it needs to fire.

Jun 27, 2009 | 1994 Jeep Grand Cherokee

1 Answer

1993 jeep grand cherokee has the 4.0 6 cyl it keeps blowin out the coil anyone have any ideas?


I once paid 350$ for a zip tie around my coil. the jeep would run for a day or so then die. The shop was stumped. They scanned it and all. Finally figured out it was the connector at the coil.

Jun 24, 2009 | 1993 Jeep Grand Cherokee

1 Answer

No spark has fuel


Check the crank and cam sensors.

Apr 05, 2009 | 2000 Jeep Grand Cherokee

1 Answer

93 jeep grand cherokee 4.0 L wont start.


start by tracing the wires back to the computer checking for breaks in the wire or corroded terminals

Mar 23, 2009 | 1993 Jeep Grand Cherokee

1 Answer

93 jeep 4.0 not starting


check the ignition coil pick up

Mar 23, 2009 | 1993 Jeep Grand Cherokee

2 Answers

1993 JEEP GRAND CHEROKEE LAREDO IM TOTALLY BAFFLED


Back up a minute...Do you have spark from the coil wire? (juice from coil) If so, change or check rotor and cap (wires do not all go bad at same time so unless they are wet, likely at least good enough to start engine)

Mar 05, 2009 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...