Question about 2006 Jeep Liberty
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
It is the blower motor resistor. Look under the passanger side dash and locate the fan housing (looks round and black in color. Then locate the resistor it will be in that housing usually withtwo ten millimeter nuts or two simple screws holding it in. unplug the harness to the resistor and remove the resistor. Part store price is approx. 50.00. Note: on aftermarket (not Jeep) resistor sometimes you have to modify the housing a little to get it in. Hope this helps.
Posted on Feb 01, 2009
You need to take the jeep to a dealer or a good mechanic who can retreive the codes out of the computer. You may have a module problem but I will not guess without knowing the codes.
Posted on Feb 11, 2009
On the back of the control panel there is a plastic connector that plugs into the fan speed control. You can unplug it and use a meter to find incoming (hotwire) take a jumper or a 6 inch peice of wire and insert it into the spade where the hot wire is wired to. Take the other end of the wire and insert it into the 1st spade in the plastic connector next to the hot wire spade this will let you know that the fan will run at the selected speed. Then pull the test wire out and plug it into the next spade and so on and so on. I am sure your fan will respond step by step , fan speed 1 then 2 and then 3. After you make this test you will know that your fan is ok. You will just have to replace the plastic connector with new spades in it. You should see some evidence of over heating on the old connector. It may be that you only need to unsnap the connector and then reconnet it and it will probably work fine. It has proberly just become partially unpluged. All the other info that I gave you early on was just to trouble shoot it. mike
Posted on Nov 02, 2009
Tips for a great answer:
May 14, 2017 | Jeep Cars & Trucks
Dec 02, 2016 | Jeep Cars & Trucks
Jul 16, 2012 | Cars & Trucks
Sep 19, 2010 | 2008 Jeep Liberty
Aug 30, 2010 | 2006 Jeep Liberty
Feb 13, 2010 | 2006 Jeep Liberty
Jan 04, 2010 | 2006 Jeep Liberty
Jan 04, 2010 | 2008 Jeep Liberty
May 10, 2009 | 2006 Jeep Liberty
Feb 11, 2009 | 2006 Jeep Liberty
Jun 16, 2014 | 2006 Jeep Liberty
1,147 people viewed this question
Usually answered in minutes!