Question about Ford Explorer

1 Answer

You go to start explorer relay clicks once - Explorer Ford Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 6,826 Answers

If the solenoid clicks but no start condition, then the starter is likely in need of replacement.

Posted on Aug 19, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

2003 ford explorer wont start hear a click under the hood, i tried to jump it and it wont start. do u think it needs a starter?


Go under the car and have a helper hold the key in the start position while you probe the wire to the solenoid for 12 volts, also do a voltage test on the positive battery cable and inspect it at the battery for acid intrusion near the positive battery post clamp, if acid has gotten into the cable the outer insulation will appear swollen and the cable must be replaced, this is a common cause of no starts on Explorers.

Jun 11, 2013 | 2003 Ford Explorer Sport

2 Answers

My truck had been running fine, got up this


it sounds like your starter relay its located inside the engine compartment fuse and relay box .good luck

Oct 23, 2009 | 2006 Ford Explorer

2 Answers

Engine will not start.turns over fine.ran fine


run scanner for trouble codes, some auto parts stores   will do this for free,check fuses, check for fuel at fuel rail, if not check fuel pump relay, you should here it click when key is first turned on, if not try to bend tabs slightly to make good contact, if no click, replace relay if so turn key off then on listen in tank with cap off for whirling sound if tank, if not could be fuel pump, sorry 

Oct 10, 2009 | 1998 Ford Explorer

1 Answer

My 2002 explored will not start. It don't crank at all. The battery is good and I replaced the starter. What could be the problem.


the wiring connection from the relay or the relay itself might be the problem. locate the relay and turn the key start it then if you hear a click sound on the relay meaning its functioning, but the contact from batt to starter may be damaged.try to jumper it.

Jun 14, 2009 | 2002 Ford Explorer

1 Answer

95 explorer on start it just clicks . relay and battery are ok can you help me to next steps


Always start with good clean secure battery terminal connections also check other end of both wires for same. Check battery with a voltmeter. Check trigger wire on relay fro 12v when key is turned to start, check main wire on starter for 12v with key on start. Check battery voltage with key on to start if voltage drops to below 9.5 starter is bad. Before changing starter, make sure you can turn the engine by hand (with key off) If you can't, don't bother with starter. Before beginning any testing battery should also be load tested to make sure it has amperage as well as voltage capacity to start car.

May 29, 2009 | 1995 Ford Explorer

1 Answer

2001 Ford Explorer Sport wont start


Even though I bought the vehicle new, there was an aftermarket security system installed. The system had a bad diode, so i removed the system and reconnected the factory wires.

Mar 27, 2009 | 2001 Ford Explorer Sport

1 Answer

Explorer just clicks when I try to start it


In the Fuse Relay Box under the Hood is a Starter Relay. Locate and Change this Relay and it should Start. The Diagram for the Box is eaither Inside the Cover for the Box or in the Owners Manual. Please Rate My Response! Thanks!

Feb 03, 2009 | 1993 Ford Explorer Limited

1 Answer

1999 ford explorer-Solenoid switch location?


solenoid switch is on top of starter . thare is also a starter relay in the fuse box under the hood . find this relay and see if it clicks when the key is turned over.get someone to turn key while you put your finger on the relay if its clicking then the starter solenoid is bad,some of thesesolenoids must be replaced with the starter.

Jan 12, 2009 | 1999 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...