Question about 1995 Cadillac Eldorado

1 Answer

My car is pulling reallly hard. When im on the brake it idling to 1 1/2. And when I cut it off I hear a ticking noise?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,190 Answers

THE THROTTLE BODY MAY BE DIRTY. GET A CAN OF CARBERATOR CLEANER REMOVE RUBBER TUBE ATTACHED TO TOP OF ENGINE ON DRIVERS SIDE SPRAY CLEANER ON CLEAN RAG OPEN THE THROTTLE PLATE BY HAND REMOVE ALL BLACK CARBON BUILD UP FROM INSIDE OF THROTTLE BORE ANB ON THE PLATE TUN KEY ON THEN OFF 3 TIMES THIS MAY REPAIR THE PROBLEM

Posted on Aug 19, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

1984 Honda Accord Brake Problem


well aside from the boosters you may also want to check the possitioning rotor and calipers. there is a possibility that something slipped, or leaked, check for brake fluids and try to trace where it is comming from.

the picture below shows how to disassemble the brakes of an Accord, the only special tool you will need is a ball joint fork to seperate the upper and lower ball joints. You have to remove the whole steering knuckle assembly to get to the bolts in back of the rotor and hub assembly.

b8487ef.gif
hope this helps

Aug 05, 2008 | 1984 Honda Accord

1 Answer

I HEAR TICKING IN THE ENGINE AND IM NOT SURE IF IT IS MY TIMING OF A LITTLE OR WHAT


The ticking is most likely to be the injectors. You will hear these prior to the engine starting when the ignition is at position two as the fuel pump builds pressure in the fuel line. If the ticking is loud and can be heard after the engine has started this could be a noisy cam shaft. Make sure your oil levels are OK and if the engine is running fine and pulling well do not become overly concerned about additional engine noises. If the engine starts to misbehave then that is the time to chase these noises down.

May 25, 2010 | Honda Accord Cars & Trucks

1 Answer

Hesitation in acceleration on my 92 audi 80 quatto


Run the car fo a while. Turn it off and wait about 30 seconds. Pull the hose off the booster. You will hear a loud rush of air entering the booster to fill the void. If not the booster is leaking. It will also cause all sorts of idle and off-idle acceleration problems. Did you check the hose from the engine to the booster? Was there a chack valve in the line too?

Feb 06, 2010 | 1992 Audi 80

1 Answer

Ford Taurus: rough idle in drive and reverse


it could be that the tick over is two slow in brive,,,
set it up to tickover at 850,,950 rpm (in drive)
or it could be a gear box fult like the drive plate has a crack in it,,,letting the torque converter slap about,,,
chech tick over first,,, bont adjust tick over in gear unless the brakes are held hard on,,,

Oct 31, 2009 | Ford Taurus Cars & Trucks

2 Answers

I hear clicking noise when I make a right turn only


there is a TSB(technical service bulletin) available at your dealership for that. Im pretty sure thats the cv shafts making that noise. its very common.

Aug 19, 2009 | 2004 Infiniti G35 Sport Coupe

1 Answer

Popping noise


Inner tie rods could make the same noise your describing. Do this......with your car in park and at idle, slightly turn you wheel from left to right, just a slight ****. 1/16 of a turn. Increase the pace from left to right, then slow down the pace. You should feel a bump in the steering wheel almost like something is tapping it. If so, have your inner and outer tie rods checked. Actually, have the steering gear checked also for leaks and wear.

Nov 01, 2008 | 2000 Chrysler LHS

Not finding what you are looking for?
1995 Cadillac Eldorado Logo

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...