Question about 2008 Dodge Caliber

1 Answer

Gascap sensor light - 2008 Dodge Caliber

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 117 Answers

Just means the gascap could be loose and not allow the gas vapors to build up enough for the evap. system. solution is to tighten the cap.

Posted on Aug 19, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gas cap light came in jeep patriot 2008


Start by rebooting the as explained regkyl.
If issue returns then get a new gascap and reboot again. The seal on your cap is maybe worn out.
If issue still return then you'll have no choice to go and have the sensor checked and hope the problem is not with the cluster...

Apr 01, 2014 | 2008 Jeep Patriot

1 Answer

2006 dodge caravan gascap light is on with malfunction light


Presumably you checked to be sure the gas cap is indeed on? if so, then you either have a faulty gas cap or a faulty sensor to the gas cap. Try replacing the gas cap first (you need a factory one for the sensor to work properly)

Oct 18, 2013 | 2008 Chrysler Sebring

1 Answer

07 pacifica gascap light will not go off


Scan for emission fault then follow the correct diagnostic procedure it may have a large leak in the emissions some where

Aug 30, 2012 | 2005 Chrysler Pacifica

1 Answer

My service engine soon light came on checked the code it said something about the evap system ?


There are a couple of different issues on this.

First off, the actual cel (check engine light) code would be extremely helpful it will be Pxxxx

Other than that, a general troubleshooting guide would be to check your gascap.
Remove the gascap, check for cracks in the rubber seal
Check for dents etc on the gas filler neck which would prevent a good seal
Reinstall the gascap ensuring it clicks a minimum of 3 clicks
If this is your problem, your code should go away in a few days. If you find problems with the gascap or filler neck, etc. then go ahead and repair them. This is the most common cause of evap issues.

The other issue i have seen with the evap system on a '01 blazer is the pressure sensor on the fuel pump going bad. Good news is that this part is roughly $40 dollars. Bad news is you may have to drop the fuel tank to get to it since it's mounted on the fuel pump most of the time, and the fuel pump is on the top middle(ish) of the fuel tank. I don't recommend dropping the fuel tank full. It'll weigh a lot. (28 gal x 6.1 lbs) + tank ~75 lbs.

Aug 12, 2011 | 2001 Chevrolet Tahoe

3 Answers

I took my Aspen07 to the shop and they replaced the gascap with a factory gascap, cleared the codes and the gascap message is still on as well as the check engine light. Any suggestions?


the check engine light is most likely evap system large leak which is what causes the gas cap light it probably needs a nvld pump or it has a leaking evap tube under th vehicle.

Dec 15, 2010 | 2007 Chrysler Aspen 4x2

3 Answers

How to shut off gascap light chrsler aspen check engine light goes off but because gascap light stays on check engine light returns. So how can i clear gascap light


You may have a faulty gas cap. If you are tightening the cap down securely the light will go off after the car is driven about 40 miles. I suggest installing a new gas cap which should cost about $15 at your local auto parts store. *** Please rate me on this answer.***

Jun 05, 2010 | 2007 Chrysler Aspen 4x2

1 Answer

Gascap light comes on when i start up car


you have a bad gas cap replace it with a new one
they old one is not sealing right

Apr 21, 2009 | Chrysler Aspen Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

483 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...