What are the torque spec. on a 2005 dodge diesel 3500 exhaust manifold?

Question edited for clarity.

6 to 8 ft lbs. It is so little is is measured in INCH pounds. 72 in/lbs is the torque, which equates to 6 ft/lbs.

2015 Dodge Journey 3.6L Engine Torque Specs

dodge-specs.com https://dodge-specs.com > cars > 2015 > journey3.6

The intake manifold bolts can be torqued down to 8 ft-lbs regardless as to whether it is the lower or upper manifold. The ignition coil assembly can be torque ..

..

Exhaust Manifold To Cylinder Head - 9.58 ft lbs
Exhaust Pipe To Exhaust Manifold - 20 ft lbs
you can check it out here, also all other torque specs for your engine.
Torque Specs Database

The hub bearing retaining bolts are 150 ft. lbs the center axle nut primary torque 135 ft.lbs rotate 5-10 times increasing torque by 50 ft.lbs until final torque of 265 ft.lbs is reached

Here's a Autozone repair guide link on your manifold torque specs. Repair Guides Engine Mechanical Components Intake Manifold AutoZone com

32 Ft/Lbs

3.9L V6 5.2L & 5.9L V8's

flywheel bolts 55 ft lbs.

5.9L ( 24 valve ) 6-cylinder diesel

flywheel bolts 101 ft lbs.

8.0L V10

flywheeel bolts 55 ft lbs.

There is no torque specs,this nut has to be tightened back like it was ,the best thing to do,was,to late now,is to use a torque wrench to remove the nut,and remember the torque,and when replacing it,torque it back to that spec,the reason being,there is a crush sleeve between the front pion bearing ,and the rear pinion bearing,and it has to be crushed to a certain amount,to aquire deepness into the ring gear,anyway just give it about 25 lbs torque,any more the crush sleeve will crush even more and the deepness of the pinion will be too much.

a cracked manifold, donut seal,flex joint or egr valve

cam sprocket is 250 in. lbs. cam tensioner and bearing caps are 105 in. lbs. exhuast manifold is 200 in. lbs. intake is 105 in. lbs