At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Trans was overhauled, when car reaches operatring tempreture OD light comes, and tranny starts to shift a little fast. Then sometimes it will not come on at all... V-6 2001 escape. 91,000 is looks imaculate.
Re: Trans was overhauled, when car reaches operatring...
HAVE A SCAN FOR FAULT CODES , I HAVE SEEN FORD ECM'S NOT RETAIN A CODE IN MEMORY FOR A TRANS OVERHEATING , ALSO WHEN THE LIGHT COMES ON DON'T TURN OFF UNTILL SCANNED
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
First thing have the tranny control module checked for fault codes, if nothing shows up have the transmission fluid and filter changed and check the trans plug for water intrusion, if that fails to show anything you likely have a failed transmission and will need to have it rebuild. Expect to pay about $3000.00 to have it rebuilt.
there inside the tranny you have to remove the pan to see them but thats not going to be your problem go buy a can of TRANSX first!! and try that if that helps then you need to plan on rebuilding your tranny or replacing it
Check linkage at tranny, the new car use a cable to shift, Sometimes the cable slips within cover due to break in cover or cover ends. remove cable at tranny and shift by hand.Replace cable and see if it has the same amount of travel.
there is a sensor on the tranny called nsbu neutral saftery back up switch. this tells the computer what gear the tranny is in when to shift, and controls the indicator lights get it fixed before you damage the tranny
It sounds like your input clutch seals are rolling. Is the check engine light on. It could also be the pressure control solenoid could be causing the problem aswell
If the trans has a whine and shifts a little hard then you need to take if to a service center and have the trans flush and filter changed this might correct the problem. But if you have never had the trans fluid change and have 100,000 on it trans might be going bad. Trans fluid and filter should be changed every 40,000 miles.
Your speed sensor in your trans. needs to be checked out sounds like its not working or not getting a good signal until its generating enough power and speed to start until it reaches 30 MPH. Check that out sometimes it could just be some dirt on it. It all makes sense the ABS light is on because its not reading the speed of the tires, and the AOD light is on because It has no idea when to shift into overdrive without knowing how fast its going. I sure Hope that Helps You Out, And Thanks, Bear001
×