Question about 1989 Toyota Land Cruiser
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Thank you -since found the answer
Posted on Oct 03, 2009
Testimonial: "Had a quick response with an offer to answer my enquiry- simple question was able to source answer else where by then. Great idea conceptually"
Yes, it's possible to change the seal after removing the balancer.
If the balancer shows signs of scratching, wear at the place of the seal, change that part too!
To remove the old seal, drill 2 small opposite holes in the seal flange ( there is metal in it ).
Screw 2 (parker) screws in the holes, so you can pull the seal out gently.
Grease the new seals' inner race, and put some sealant paste to the external race.
Push it back in place with a wooden piece ( drill a hole in the center for the crankshaft end )
Grease the outher race of the balancer. This will help the seal come gently into place.
Posted on Nov 01, 2009
4.5qt for oil change
5.0qt for dry engine
Unless you have upgraded to a 5qt baffled oil pan then the above is the right measurement.
Posted on May 23, 2010
Tips for a great answer:
Oct 31, 2010 | 1990 Mercedes-Benz E-Class
May 19, 2010 | 1989 Volkswagen Golf
Nov 01, 2009 | 1989 Toyota 4Runner
354 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: