Question about 2000 Cadillac Seville

1 Answer

My 2000 seville has an intermitant misfire when reversing and also when you put engine under load it then clears and runs fine

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cadillac Master
  • 17,970 Answers

It means that more than one cylinder has a misfire history. PO301 would be cylinder number 1 misfire. PO302 would be number 3 cylinder misfire.

We are assuming that you have an scan number there or any fault code P0300 may mean that one or more of the following has happened:

  • Faulty spark plugs or wires
  • Faulty coil (pack)
  • Faulty oxygen sensor(s)
  • Faulty fuel injector
  • Burned exhaust valve
  • Faulty catalytic converter(s)
  • Stuck/blocked EGR valve / passages
  • Faulty camshaft position sensor
  • Defective computer

Possible Solutions: If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.

If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.

Random misfires that jump around from one cylinder to another (read: P030x codes) also will set a P0300 code. The underlying cause is often a lean fuel condition, which may be due to a vacuum leak in the intake manifold or unmetered air getting past the airflow sensor, or an EGR valve that is stuck open.

Hope help with this.

Posted on Aug 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 cavalier 2.2 has engine misfire only when you put in any forward gears park is fine nuetral is fine and reverse is fine


The ECM does not put the oxygen sensor circuit into action when the vehicle is in any gear other than drive. I have seen a bad ground on the ecm cause this.

Apr 15, 2018 | Cars & Trucks

1 Answer

2000 Ford mustang. engine skipping and check engine light flashing. I have checked plugs and wires and they seem fine.


It sounds like you have a misfire. Does it miss more under a load or does it miss primarily,at idle. If under load, it is likely ignition related. Spray water on the wires and coils with the engine running. If they are carbon tracking it will be very obvious as the engine will miss worse.

Jun 25, 2014 | Cars & Trucks

1 Answer

I have a 1999 suburban with a 5.7 vortec the engine wont build rpm while moving,but revs freely in nuetral or park.If the computer senses movement in forward or reverse the engine misses such as a rev...


The computer can't sense movement. An engine with worn spark plugs or bad coils can run perfectly fine at idle and begin misfire the second you put it into gear or under loads. Plugs/coils misfire most when under load. Have you checked them?

Oct 18, 2017 | 1997 Chevrolet Suburban

1 Answer

2000 Kia Spectra


http://www.kiatechinfo.com/index.asp

Good source for Kia its free to register NO STRINGS

May 16, 2009 | 2003 Kia Spectra

1 Answer

Engine misses when placed under load


replace the plug wires this will fix your secondary ignition breakdown. the egr code is due to a bad dpfe sensor which is for back pressure on egr valve.this will not cause misfire.

Feb 19, 2009 | 1991 Ford F150

1 Answer

Problem with the motor intermitent


check engine light flashes or comes on? -jeff

Aug 01, 2008 | 2000 Pontiac Bonneville

Not finding what you are looking for?
2000 Cadillac Seville Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

Marvin
Marvin

Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...