Question about 2001 Cadillac Seville

1 Answer

How many hours of labor does it called for to put on a plenum gasket on a 2001 cadillac sls?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cadillac Master
  • 14,036 Answers

IT TAKES 1.5 LABOR TIME.

Posted on Aug 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 Cadillac SLS seville and when it in park or neutral the rpms rove up fine but when I put it invdrive or reverse I step onbthw gas it won't go pass rpm 1 what will cause this


Something inside the transmission. TCC solenoid/valve could be a cause. Have the codes checked, even if the check engine light isn't on.

Jan 18, 2015 | 2001 Cadillac Seville SLS

1 Answer

Coolant low, steam out of exhaust, and rough idle at start,


Hate to tell you this bud but you have a head problem most definitely
Head gasket is blown or maybe even a cracked head
Bad news is most caddy engines have problems with head bolts upon removal
I would be looking for a used engine

Mar 02, 2014 | 2001 Cadillac Seville SLS

1 Answer

Intake manafold gasket


If you are just talking about the cost of the gaskets there is kind of an upper (plenum) and a lower intake set. If you just need the plenum gasket they are only about 30 dollars. If you need the entire set there are a couple of option. Just a regular set runs you about 70 (that's both the upper plenum and lower intake manifold but FelPro puts out a great gasket set called "permadry" and the runs about 165 dollars. If you were looking for labor cost it depends on the hourly labor rate of the shop you are using. The labor guide says that if you are replacing both upper & lower it shows 3.4 hours in labor. If it's just the plenum it says 2 hours of labor. Hope this is what you are looking for and by the way I am going by the most common engine found for the Windstar for that year and that engine is a 3.8 liter. If you happen to have the 3.0 the prices and labor hours may be different.

Mar 31, 2012 | 2000 Ford Windstar

1 Answer

I have a 2002 cadillac dhs my service engine light came on. got codes P0174 and P171 could you tell me what they mean


P0174 System Too Lean (Bank #2)
P0171 System Too Lean (Bank #1)

System to lean means that a fuel injector or injectors may be plugged up, or the oxygen sensor is sensing too lean of a condition.

How many miles do you have on this engine?
Have the O2 sensors ever been changed?

When was the last time you had a tune up?

Dec 18, 2010 | 2002 Cadillac Deville

1 Answer

2001 Cadillac Seville SLS Car does not run other


Well, the first thing one should check is the transmission fluid level. Add Dexron ATF to the transmission until full when the vehicle is at normal operating temperature after 30 or 40 minutes of driving.

Secondly, if the car's transmission hasn't been flushed and filled in 30,000 mi. it's recommended that you do so as normal maintenance. This service typically costs about $100 or so.

If the car only runs forward but not reverse, a solenoid may be plugged up with clutch dust, or it's shorted out and needs to be replaced. However, tearing down a transmission on a 2001 Cadillac Seville is rather expensive, in the thousands of dollars.

One might consider getting a good used transmission that has a guarantee on it and have it installed, or have the one in it rebuilt.

Good luck on this repair.

Nov 05, 2010 | 2001 Cadillac Seville

1 Answer

My 2001 Olds Aurora idles rough, could it be the map sensor, or mass air flow sensor. It runs fine going down the road.


If this is the 4.0L engine it is very common to have the Air Intake Plenum gasket crack. About a $30.00 part and 2 hours labor.
First, see if you have any codes. For the situation I describe about you should see P0171/P0174.
The other sensors could also be the issue. Most ODB-II scanners will allow you to read "live data". This will go a long way in telling you where the problem is.

Aug 20, 2010 | 2001 Oldsmobile Aurora

1 Answer

Oil change dash computer on 2001 cadillac sls


never come across this before and i would need to see the engine layout to work out what could be causing it but if its low oil pressure then add a tin of STP or wynns and see what happens

Jun 03, 2010 | 2001 Cadillac Seville

2 Answers

1999 cadillac seville sls it over heats when in drive


how many miles are on it? if you have over 70k the head bolts may have let loose and allowed the head gaskets to leak they all do it

Nov 30, 2009 | 1999 Cadillac Seville

Not finding what you are looking for?
2001 Cadillac Seville Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...