Question about 2004 Ford Freestar

1 Answer

Two of the LED's in my 2004 Ford Frestar have burned out. How do I replace the LED bar? Do I have to remove the entire back panel of the back door to access it? And if so, how? Thanks.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 92 Answers

Yes look for screws at bottom of panel un-screw and left.

Posted on Aug 11, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove inside rear door panel on fiesta 2015


Ford Fiesta Plastic Interior Door Panel Removal Guide ...

www.paulstravelpictures.com/Ford-Fiesta-Interior-Door-Panel-Removal-...
Ford Fiesta Interior Door Panel Removal Guide How to take off the plastic interior door panels in a 6th generation 2009-2015 Ford Fiesta to upgrade the ...

Ford Fiesta inner door panel removal (I removed the top one ...

www.fiestafaction.com/.../44959-Ford-Fiesta-inner-door-panel-removal-...

Jan 19, 2015 - 10 posts - ‎3 authors
This is an excerpt from the manual: Remove the rear door window glass. ... Route theinterior door handle cable and door lock actuator electrical connector through the ...Last edited by WildmaninME; 01-19-2015 at 07:41 PM.

Ford - door panel removal - fiesta - YouTube

? 2:19
https://www.youtube.com/watch?v=1URT13Yusjg
Oct 19, 2013 - Uploaded by one2three
this is the removal of a door panel from a ford fiesta 2001. ...Replacing Broken Inside Door Handle on 2007 Ford Fusion - Duration: 5:32. ... Ford Fiesta 1.25 2004 - Cleaning and adjustingrear brake drums - Duration: 8:47.

How To: 2012+ Ford Focus Rear Door panel removal(SE,ST ...




Jan 13, 2016 | Cars & Trucks

1 Answer

Where is a/c orificie tube located in ford frestar 3.9l 2004


Should be in the line coming from the condenser. It will have a wider section just past the connector where the orifice tube is.

Aug 14, 2012 | Ford Freestar Cars & Trucks

2 Answers

The window on my 2004 Ford F-150 fell into the door. How do I take the door apart to put the window back on track?


There are usually screws holding the door panel in place. Look around the edge of the inner door panel for any screws. There are also some screws under the arm rest on the door. Any items that penetrate the door panel must also be moved out of the way or removed (like window cranks).
Once you get all screws and obstructions out, the panel moves away from the door and lifts up and away. You may find that the window didn't come off track, but you may need to replace some parts as well.

Gary

Aug 09, 2011 | 2004 Ford F150

2 Answers

My 2005 ford frestar is leaking water in the back hatch are and was wondering were it might be coming from


I had water coming into the rear storage area. Finally found where it the leak was. The plastic panel on which the license plate mounts was leaking around the panel allowing water to run down onto a little ledge area and the enter the rear storage well at the left rear corner of the storage well. I have tightened the nuts that hold the panel against the gasket and if that does not stop it, I will loosen it an put clear silicone seal around the pane. It was hard to figure out! I had to remove the rear trim to see where the leak was. Hope this might help.

Feb 19, 2011 | 2005 Ford Freestar

2 Answers

My 2004 freestar refueling problem


This is a venting problem. When the gas goes in, the air has to come out. If the air vent is blocked, the fuel wil spit back as the air forces it's way out the filler pipe.

Sometimes the vent pipe is inside the filler pipe, sometimes it runs alongside the filler pipe.

For the 2003 Winstar, it is a separate fresh air hose. Frestar was it's replacement in 2004 so it may be different. Check for a plugged or kinked hose.

Feb 27, 2010 | 2004 Ford Freestar

2 Answers

Replacement of the side reaerview mirror on a


so you don't need to change the housing, but just the panel the mirror sits on right? If you mean the entire unit, then you'll need to remove your door panel (screws are by the door handle, arm rest, under door and side of door) and remove the cover adjacent to your mirror to remove the bolts to remove the mirror.

If it's just the back and the mirror, you'll need to angle the mirror until you can see the release clips on the back of the panel that mounts it to the housing (Pivot Point)... be very careful as the clips can easily break....

Aug 10, 2009 | 2004 Dodge Ram 2500

1 Answer

Looking for a free online repair manual for 2004 Ford Expedition


Pretty simple actually. Sounds retarded but here ya go:

Unscrew all the screws visible. This includes the armrest if applicable.

Get a tool from your local auto parts store that looks like a small pry bar that has a little slot in the middle. it almost looks like the weed puller you use to remove dandelions. Seriously...you'll know it when you see it. This thing is a gem and works on ALL door panels. Slip it inbetween the door panel and the metal part of the door and start popping out the panel. You really want to get behind the plastic fastners if you can. Once you get to panel loose, you want to detach any electrical connectors from the door panel switches.

After that, use a little force to work it upwards to clear the door itself. the seal that is butted up against the glass is sometimes tight.

Do what you need to do and installation is in reverse order.

By the way, that tool is less than $10.00!

Good luck and post if you have any problems.

Mar 16, 2009 | 2004 Ford Expedition

1 Answer

My 2004 Ford Freestar Dash light fade in and out


check for loose wire behind the alternator when the light are fading our running on the battery only the alternator ir not charging get that check as soon as you can the frestar gonna stall soon thanks pierre

Dec 15, 2008 | 2004 Ford Freestar

Not finding what you are looking for?
2004 Ford Freestar Logo

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...