Question about 2004 Lexus RX 330

1 Answer

The idle speed on our 2004 Lexus RX330 is 500 rpm. How do I increase the idle speed to 700 RPM?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,309 Answers

Unless you have the capability to reprogram the computer you can't, they are all preset programs

Posted on Aug 07, 2010

Testimonial: "Thank you for the fast and helpful answer!"

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the factory set idle speed for 2004 Chevrolet 5.3Vortex V8 engine ?


A lot of vehicles idle on average from 600-700 RPM. Standard is +/- 100 RPM

Feb 06, 2018 | Chevrolet Cars & Trucks

1 Answer

What is the ignition timing for 2002 nissan hardbody 2000i 16v


Here are the 3 engines listed for this year. IGNITION TIMING

2002 Nissan/Datsun Truck Frontier Pickup 2WD 2.4L SFI 4cyl

The Ignition Timing

18-22 DegreesBefore top dead center - When throttle positionsensor disconnected and using suitably programmedscan tool.When adjusting idle speed, set parking brake & chock drive wheels, curb idle speed (750-850 RPM)transmission in neutral.

IGNITION TIMING

2002 Nissan/Datsun Truck Frontier Pickup 2WD 3.3L SFI 6cyl

The Ignition Timing

8-12 DegreesBefore top dead center - throttle position sensorharness disconnected.When adjusting idle speed, set parking brake & chock drive wheels, curb idle speed (700-800 RPM)transmission in neutral.

IGNITION TIMING

2002 Nissan/Datsun Truck Frontier Pickup 2WD 3.3L SFI SC 6cyl

The Ignition Timing

8-12 DegreesBefore top dead center - throttle position sensorharness disconnected.When adjusting idle speed, set parking brake & chockdrive wheels, curb idle speed (700-800 RPM)transmission in neutral.

Jun 05, 2015 | Nissan Hardbody Cars & Trucks

1 Answer

Increase then decrease idle when engine is cold especially


cold engine idle surge. (problem)
RPM range of surge not stated
300-700 or 800 to 1500? (range is critical to diagnosis)

bad fuel
running summer fuel in winter (running old fuel?)
needs a tune up bad, see the list in the operator guide.
idle speed controller,sticking or EGR valve same. (clean them)
location not stated, so cant guess about local air temps.?
no other symptoms, lack of engine power? etc?
was it ok last week, or better, when was the last time it was OK?
1week, 1year?
surge , causes, on a tuned engine might be:
1: too lean. so lean the ISC can not control idle. rpm low, stalling
2: too rich, flooding, stalling, spark plugs foul (look at them)
3: weak compression in 1 or more cylinders.
4: bad spark.
5: air leaks, in the plenum causing , ISC to lose control.
why high RPM?

especially?
well that means it fails hot too.
and there is a simple tests. for hot surge.
is engine fully hot? 180F and holds solid there?
say rpm is about 800
and you turn on head lights, heater fan and (not AC) and defrost.
the RPM must hold or the ISC is failing.
ISC -= idle speed controls. (all EFI has this function)

Oct 28, 2013 | 1996 Honda Prelude

1 Answer

High --1600 rpm ?? rpm idle


The normal idle speed is below 1,000 rpm...between 800 to 900 rpm. I suspect that the idle-air control motor has seized and can no longer automatically adjust the engine's idle speed. This part is also responsible for slightly increasing idle speed when the airconditioning is switched on to compensate for the added engine load. Some cars even have a "step-up" solenoid to increase idle.

When replacing the idle-air control motor, remember to clean the port that IAC motor goes into; there will be some carbon build-up that may prevent the part's cone-shaped valve from seating properly. A can of intake valve spray helped along with some Q-tips works well.



Hope this helped.

Have a great day !!!

Apr 07, 2011 | 1992 Buick LeSabre

1 Answer

I have this problem for quite a bit. The idling speed when engine started cold is between 700-800 rpm. As the engine gets hotted idling rpm increase to almost 1000rpm. If idling is adjusted back, the rpm...


There appears to be a thermal movement of choke mechanism that comes about once vehicle is warmed up. Check the chock connections, hot water pipe and linkages tight or clear.
gazakat

Oct 18, 2010 | Nissan Sentra Cars & Trucks

1 Answer

Rover 75 v6 starts no problem runs 1000 rpm then


check idle speed sensor on your intake manifold around 700 to 750 rpm is normal ,air temp may efect idle speed .

Sep 17, 2009 | 1999 BMW 323 Series

1 Answer

Idle adjustment 2002 chrysler sebring


Your idle is electronic you can't adjust this. Or at least you shouldn't. You have a sensor for speed and idle. In most cases depending on where you are the idle should drop to 700 rpm in most 2.4 if this helps you. When the car is cold it can range between 700 and 1000 rpm.

Jan 05, 2009 | 2002 Chrysler Sebring

Not finding what you are looking for?
2004 Lexus RX 330 Logo

Related Topics:

905 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

918 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...