Question about 1989 Ford Taurus

1 Answer

I was driving down the road and i had to stop the break peddle was touching the floor and the car still did not stop

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 24 Answers

Check your master cylinder fluid level. only use brake fluid to bring to proper level. if it's empty you have a leak somewhere in the hydraulic system and need to get it repaired. fill it up push/pump the pedal look under car and at backside of each wheel you will see where it's leaking. If you see fluid you need to get it repaired. ~a car that won't run is an inconvenience and a car that won't stop is a problem~

Posted on Sep 27, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Breaks go to the floor


Then you have a massive leak somewhere as the brake peddle should not go all the way to the floor without some low break fluid indication. I would check brakes at each wheel as something isn't right or your not seeing it. Have someone pump the pedal and look to see if after the wheel is removed that the brake actually tightens and loosens. Remember that 4 wheels means 4 brakes, but master brake cylinder (where you add brake fluid) could be bad.
tandem-master-cyl2.gif


May 06, 2014 | Pontiac Grand Prix Cars & Trucks

1 Answer

Stalling


need to scan for code autopart store should scan it for free and give you a print out of code.

Feb 15, 2013 | 2006 Kia Optima

1 Answer

I own a 1995 Audi 90cs. My clutch peddle started being dead tell half way down then got preshure. Now there is no preshure and the peddle sticks to the floor. There was no slipping in the clutch so I


You need to replace the clutch slave.....Ii recently did mine, after the installation it was stuck too.......the way I fix it was I had a friend pumping the clutch by hand while I bleed it under the car, it took about 15-20 minutes before it got hard again.
Good luck!

Aug 01, 2012 | 1995 Audi 90

1 Answer

My 1988 dodge Dakota 3.9 3 speed automatic 2 w Dr.idles rough and sometimes dies at a stop light and won't restart unless I put the gassed peddle to the floor.when it does finally start I have to keep...


Replace your hose going from intake to brake booster ( vacuum leak) check all other hoses also. Clean the throttle body. And a tune up probably wont hurt either.

Jun 09, 2017 | Cars & Trucks

2 Answers

Drive vehicle down the road for 20 minutes and come to a stoplight engine stops when you take foot off gas peddle and go to apply brake. To keep vehicle from dying you have to hold the gas peddle down


Have you changed the timing belt? or timing belt guides? How many miles? This does not necessarily have to do with fuel.... Could have to do with air intake or timing as well....

Jun 12, 2012 | 1996 Dodge Ram

1 Answer

Brake peddle will stop vehicle, but if I keep pumping, the brake peddle will go to the floor. Is this the booster or master cylinder?


this sounds like the master cylinder check the rear brakes to make sure that they are not leaking break fluid.

Good luck

Dec 02, 2009 | 2003 GMC Envoy

1 Answer

Spungy brake peddle and goes to the floor gm says nature of the beast stops ok but doesn't feel right


that is one of the wosrt ABS system it dose cause a soft peddle but you can sometimes adjust up the rear brakes to help this problem,also find a dirt road and slam on the brakes just enough to cause the ABS pump to kick on it will also give you a better peddle

Jul 13, 2009 | 1997 Chevrolet Suburban

1 Answer

Problem with my brake system


sounds like your servo is at fault try bleeding all 4 wheels with engine running right wheel warped disc

Nov 16, 2008 | 1989 Ford Thunderbird

1 Answer

EXCELERATOR


The problem is Trailblazers are pieces of junk...I own one so I know

Jul 16, 2008 | 2002 Chevrolet TrailBlazer

Not finding what you are looking for?
Cars & Trucks Logo

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...