Question about 2004 Ford Taurus

1 Answer

Refrigerant fill location - 2004 Ford Taurus

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 14,036 Answers

FOLLOW THE LOW PRESSURE LINE FROM AC COMPRESSOR TO THE ACCUMULATOR TO THE EVAPORATOR.LOOK FOR A LINE WITH A BLUE CAP.THAT YOUR RECHARGE PORT.

Posted on Aug 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My air conditioner is blowing hot air, where is the port so that I can add refridgerant?


The charging port is located in the larger of the two hoses/lines that come from the AC compressor, the fill port will accept only the right fitting from the charging source hose fitting. Before you add refrigerant you need to locate the leak, the refrigerant doesn't just disappear, it leaks out somewhere.. My guess would be the AC compressor front seal.

Jun 30, 2016 | 2004 Hyundai Santa Fe

1 Answer

REFRIGERANT FILL FOR 1993 BUICK SKYLARK


It is on the silver tube that runs from the rear of the engine compartment out of the firewall. If you trace it the whole way, you will find it. It may be very close to the AC compressor.

Aug 07, 2012 | 1993 Buick Skylark

4 Answers

I am trying to locate the port for ac refrigerant on a 2002 ford focus


To add refrigerant to your A/C system, remove front passenger side tire, remove plastic inner liner of whel well ( I only removed the torx bolt that holds it to the fender and folded it back) There is a silver canister there with a small tube with a black cap, that is the low side where the refrigerant goes. Get the hose attachment wit a gauge so you don't overfill, and a can of r134a, I used duPont Suva, and follow the directions on the hose attachment. Cost around $35USD total and about 45minutes and I now have cool air blowing.

Jun 01, 2011 | Ford Focus Cars & Trucks

2 Answers

I have a 2000 pontiac sunfire, a/c blows warm are...i have replaced refrigirant twice, but cools for one day and back to warm, and gauge on refridgent will read low each time i filled it...whats my...


Put some ac dye in the system.Which you can buy in stop leak cans from your local parts store.You have a pretty big leak from what it sounds like.The dye will show up were the leak is.

Jul 25, 2010 | 2002 Pontiac Sunfire

1 Answer

Air conditioner does not blow cold air


if it's not cold, then the refrigerant has leaked or it's low. A local shop can evacuate the system and check for leaks prior to filling with refrigerant. They can easily locate leaks in hoses, fittings, etc...
It's quite possible that there isn't any leaks ...it may be low on refrigerant, but it's best to check...saves $.

May 31, 2010 | 1995 Jeep Grand Cherokee

2 Answers

Where is the thermastat located on the 2001 pt cruiser


Here are the instructions from chiltons.

Removal & Installation
  1. Disconnect negative battery cable.
  2. Drain cooling system below thermostat housing level.
  3. Remove thermostat.
  4. Disconnect engine coolant temperature sensor.
  5. Disconnect heater supply hose.
  6. Turbocharger equipped vehicles:
    • Recover the refrigerant from the refrigerant system.
    • Disconnect A/C suction line from A/C compressor.
  7. Remove housing attaching bolts.
  8. Remove housing and gasket.
To install:



  1. Clean all gasket sealing surfaces.
  2. Install gasket and housing. Tighten bolts to 20 ft. lbs. (28 Nm).
  3. Turbocharger equipped vehicles:
    • Connect A/C suction line to A/C compressor.
    • Evacuate the refrigerant system.
    • Charge the refrigerant system.
  4. Connect heater supply hose.
  5. Connect engine coolant temperature sensor.
  6. Install thermostat.
  7. Fill cooling system.
  8. Connect negative battery cable.
Please do not hesitate to ask further questions about your vehicle.
please do not forget to rate and comment about your experience with fixya.

Dec 27, 2009 | 2001 Chrysler PT Cruiser

2 Answers

Where do you add refrigerant to a 97 sho?


The high pressure port is in front of radiator fill reservoir. The low pressure port is located by the passenger strut tower.

Jun 24, 2009 | 1997 Ford Taurus

1 Answer

2001 honda civi


i wont start untill it sees substantial amount of pressure in the system try locating the ac pressure switches, should be one or two of them on the ac line unplug them and jump them with papar clips dont run for too long without refrigerant or you will damage the compressor and be sure the compressor came filled with oil or fill it yourself -jeff

Jul 07, 2008 | 2001 Honda Civic

Not finding what you are looking for?
2004 Ford Taurus Logo

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...