Question about 1996 Honda Accord

1 Answer

Thermos stat location - 1996 Honda Accord

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 977 Answers

You will find the thermostat in the housing where the top radiator hose goes onto the motor.........hope this helps....cheers

Posted on Aug 10, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


you changed the thermo switch and relays and it didnt fix it
did you test the fan motor itself

the fuse box cover should have a fuse layout diagram
engine cooling fan

look for a 30 amp fuse

they usually near the fan relays

is the air con cooling fan working with air con on
and engine running


Jul 15, 2016 | Toyota Cars & Trucks

2 Answers

No heat when driving down road

The wow list:
, 1:did this before and after stat change? .
which of 4 engines, we can not guess engines,
2: what temp stat did you buy, 180 ,195, 199F? or 160f.
3: double posted, wow 3
4: what heat, the cab heater>? Ill guess that.
5: is blower in dash blowing on high.?
6: get heat in recirc mode and fresh air, ever?
7: does cluster gauge go to hot.? like NORMAL.
8:is it -40F out side, kinda matters....ask.
9: does car have clutch fan option or electr fan.?
10: is this RAD fan working correctly?
11: did you burp out all air in the system.
12: did you get level to top of rad neck , dead cold..
13: did you put the thermostat in backwards.
14; same is jiggle pin at 12pm (up) in stat.
15: is thermostat rubber new. or old and ratty.
16: DID You scan the PCM to see some very bad DTC errors? if yes, what>?

even johnny would be GOBSMACKED.!

Have heat when sitting still,but no heat driving down road, replaced water pump and the thermostat.
heat from what?

did #21 meter show normal during all this??????????
that be KEY fact #1

Feb 28, 2016 | 2005 Jeep Liberty

1 Answer

I have 2000 astro van and I'm not getting heat, I changed thermo stat and flushed heater core. Still no heat, whats the next step?

Feel your heater hoses. If both are hot, the core is circulating. If only one is hot-poor or no circulation of the core.
If the heater core is circulating, the temperature blend door may not be working to let blower air pass across the heater core, and into the vents. If vacuum operated, watch the vacuum valves as you move heater controls-you may spot the problem. Check that the vacuum line from the engine to the control switch is working and still connected. If not operated by vacuum, the controls may have cables to the heater case or may be electrically operated. You'll just have to scope it out. Good luck.

Nov 24, 2012 | Chevrolet Astro Cars & Trucks

1 Answer

My thermo stat display doesn't work on my 1998

Could be the coolant temperture sensor.

Aug 03, 2011 | 1998 Chevrolet Blazer

1 Answer

Looking for location of the thermos stat

Please see my tip at . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me.

Your thermostat is here between the valve cover and throttle body:

Nov 30, 2010 | 1999 Chevrolet Lumina

2 Answers

Cooling fans on radiator will not run. Voltage in plug at block thermostat is 5.4.this therm provides an earth switch. Bypassed the thermo to earth and fan relay engages momentarily only. Relay is ok....

The fan control thermo switch should be either "off" or "on".
Voltage should measure either +12 or 0V, depending on coolant temperature.
Replacing it should fix your problem.

Jun 20, 2009 | 2000 Daewoo Nubira

1 Answer

1998 chevy S 10 won't start in cold weather. starts just fine when around 25 degrees or so. looking into cold start valve and thermo time switch, but don't know location of either, or how to check.

a coolant temp sensor will cause this problem if it is reading warmer than it is outside this will give lean condition .the sensor is located by the t-stat follow upper radiator hose down to housing.the sensor has two wires. thanks for your question.

Feb 01, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

Thermostat replacement in 1985. Need diagram or very explicit intructions.

The thermostat housing is on the left side of the engine at the front, bolted to the side of the block with two bolts - top and bottom of the housing. Obviously, before starting, let engine cool and release pressure from system, drain out coolant (about half) so little is lost when stat housing removed. If coolant is old, this is a good time to replace it. When replacing the stat, get a SAAB stat, as it's a three stage stat, not a two stage (open and closed) as are most after market stats. If you car runs hot in traffic or hot days, consider the low temp stat (and rad fan thermo switch also) to extend engine life. Tighten the bolts to 13 ft-lb. Refill and bleed out any air. Hope this helps, give a "thumbs up" if it does; thanks Saabreur

Jul 23, 2008 | 1992 Saab 900

Not finding what you are looking for?
1996 Honda Accord Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides