Question about 2000 GMC Jimmy

1 Answer

Location of a speed control sensor in a 2000 gmc Jimmy?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 178 Answers

It's on the tailhousing of the transfer case.

Posted on Aug 07, 2010

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Molson02536
  • 3854 Answers

SOURCE: where is my 1 2 shift sensor 2000 gmc jimmy

Your transmission is electronic, it read's the the speed sensor from the yoke and relay's the information to the ECM which tell's the servos in the transmission acivate to change the gears up or down with the engine out put.

Posted on Apr 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What could keep throwing this P0507 code? Even eith a new idle air control valve?


Throttle positioning sensor.might have a vacuum leak to throttle body

May 18, 2014 | 2000 GMC Jimmy

1 Answer

Why does my 2000 gmc jimmy shut off while in motion?


It could be the Throttle Position Sensor ( TPS ) or Idle air control motor. Determining this will help be a guide. If it idles but you cannot accelerate, then it could be the Idle air control ( IAC) or the MAF ( mass air control sensor).
If it idles but stalls when you try to accelerate, then I would first suspect the TPS. You could throw a lot of money at this problem and not solve it. I would suggest getting the computer scanned to find out what codes it is throwing before buying any parts to swap.
Hope this helps!!

May 17, 2014 | 2000 GMC Jimmy

1 Answer

My 2000 jimmy wont shift into 3rd or 4th and it reaches 3000 or more rpms. its an automatic transmission. someone said it could be speed sensors. where are they located.


Its more than likely a shift solenoid sticky causing this problem.Its located inside the transmission oil pan in the valvebody.

Dec 03, 2011 | 2000 GMC Jimmy

1 Answer

2000 gmc jimmy need to know where the crankshaft sensor is located as im told that is the most likely culprit. its a 4.3 vortec 4x4 slt model if that helps.


Hello jerryparker6,
The image below shows the location of the crank position sensor.

I hope this helps.

netvan_87.png

Regards,
netvan

Apr 11, 2011 | GMC Jimmy Cars & Trucks

1 Answer

ABS Problem in my 2000 Jimmy 4x4


the best way to diagnose this problem would be with a scan tool while driving and watching the speed sensors, or check all your wheel tone rings make sure there are no cracks and they are clean, also have the computer scaned for abs codes there should be a code that may tell you which wheel speed sensor is acting up,you can also check the wiring, these seem to chaf the wiring by the control arm .a bad wheel bearing may also cause this problem, i would start with a scan of the abs system,good luck.

Feb 22, 2010 | 2000 GMC Jimmy

2 Answers

Where is my 1 2 shift sensor 2000 gmc jimmy


Inside trans. pan at the rear of the valve body. They have a wire clip which holds them in.

Jan 21, 2009 | 2000 GMC Jimmy

1 Answer

2000 gmc jimmy dont start


do you have access to a scanner to check the computer , possibly the computer has gone bad .

Dec 07, 2008 | 2000 GMC Jimmy

Not finding what you are looking for?
2000 GMC Jimmy Logo

Related Topics:

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...