Question about 1997 Toyota Camry
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Removal of the plenum is pretty straight forward. You will need to replace the plenum gasket after you remove it; the gasket is not reusable. Personally, if I was going to take the trouble to remove the plenum, I would replace the plugs and wires back there, also.
I know, I have a 93 Camry V6, and it is a real pain to do the plugs and wires with the plenum on. There are no secrets or great tips on the plenum removal, just take your time. Remember that there are different size bolts, and where they go. Please get back to me if you need any more info...Hope this helps, and thanks for choosing FixYa to resolve your issue.
The graciousness of a FixYa rating for my assistance would be greatly appreciated.
Posted on Dec 15, 2008
Yes, you have to remove the door panel.
Remove the 2 plastic protectors on the front edge, and remove the 2 brass colored screws. Next, remove the push pins from the latch side. Push in, and pull out the whole thing. Next, under the armrest, remove the screw. Lift up the power windoe control, being careful to not break the plastic retainer tab. Remove the screw under the window control. Starting at the bottom, pull out the panel, and, when all of the clips are loose, pull the panel straight up. It is best to do this with the door panel as warm as possible, like in a heated garage. Doing this outside in the cold will break all of the plastic retainer clips; they are quite brittle whn cold.
I hope this helps
Thanks for choosing FIxYa for assistance. A FIxYa rating (4 blue diamonds) would be greatly appreciated.
Posted on Feb 23, 2009
That code is for the evaporative emmisions system. Here is a link to an open forum you can go to, this will help you understand what it is, and why. The vehicle on the site is a van, but the code, and parts involved are one in the same, so don't worry about the difference in vehicle. The van is a toyota, and this is the information on the p0446 code. Hope this helps you.
Posted on Mar 08, 2009
SOURCE: power window toyota camry
Fuse box is by drivers left knee. Above this are the flashers and about 3 inches above this is the circuit breaker for the windows and door locks. breaker is silver, about 1/2 by 5/8 inch and in the center is the button you need to push in to reset. I used an unbent paper clip to press it. Make sure unit is not energized. May need to unplug breaker first. Press in center button until it clicks.
Posted on Jun 04, 2009
YES I DO. there is a switch, there where the 4 switches are on the drivers door. there should be another switch there that turns the other windows on/off. somehow that switch got turned off.
Posted on Sep 21, 2009
Tips for a great answer:
Sep 16, 2014 | 1997 Toyota Camry
Sep 11, 2017 | 1997 Toyota Camry
Dec 04, 2013 | 1997 Toyota Camry
Dec 02, 2010 | 1997 Toyota Camry
Oct 02, 2009 | 1995 Toyota Camry
Sep 21, 2009 | 1997 Toyota Camry
Jun 03, 2009 | 2006 Toyota Camry
Jan 23, 2009 | 1997 Toyota Camry
127 people viewed this question
Usually answered in minutes!