Question about 2003 Saturn ION

Open Question

How to replace 2003 saturn ion Passlock sensor and

How to replace 2003 saturn ion Passlock sensor and were is located

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: saturn crankshaft sensor

Right above the started. It can be removed from under the car withour taking the starer out. 5 minute job, one bolt

Posted on Oct 18, 2008

Ad
  • 1596 Answers

SOURCE: where is 2003 saturn ion thermostat?

FACEING the ENGINE It is At TOP RIGHT SIDE Close to Master Cylinder takes About 1 hour to Replace Have Fun its a EASY One
Please Dont forget to RATE ME Thank You

  1. Drain the cooling system.
  2. Remove the bolts that secure the thermostat housing to the water pump feed pipe.
Remove the feed pipe
  1. Remove the thermostat and retaining sleeve, noting the orientation for installation.
Installation Procedure
Install the thermostat and retaining sleeve with the dimple placed into the housing slotImportant: Lubricate the O-ring with soapy water or coolant before installing the O-ring in the water pump.

  1. Install the feed pipe that connects the thermostat housing to the water pump.Notice: Refer to Fastener Notice in Service Precautions.

    1. Install the bolt that secures the water pump feed pipe.
      • Tighten the bolt to 10 Nm (18 inch lbs.) .
    1. Fill the cooling system.

Posted on Feb 09, 2009

blueextc3221
  • 15935 Answers

SOURCE: Oxygen sensor location on a 2003 Saturn Ion-1

One is front of the cat, and one after the cat of the exhaust.
The OBD Scanner should tell you which bank is producing the error.
Bank one is the front one.

Thanks for using FixYa - a FixYa rating is appreciated!!

Posted on Feb 21, 2009

  • 1986 Answers

SOURCE: Where is the fuel filter located on a 2003 Saturn

It will be attached to the frame recessed into a nook on the drivers side just forward of the gas tank.

Posted on Nov 17, 2009

Testimonial: "Couldn't have been more clear if you drew a picture. Thanks."

Molson02536
  • 3854 Answers

SOURCE: how do you change the downstream oxygen sensor in

Downstream O2 sensor is the O2 sensor after the Catalytic converter. Jack the car off the ground so you can get under it, disconnect the wire leads and with a close end wrench. Snake the wire leads through and wrench and place the wrench one the O2 sensor and with a hammer, tap the wrench to break lose the O2 sensor from the exhaust pipe. Once the O2 sensor has loosen up, just remove and install the new O2 sensor. Reconnect the wire leads, start the car and listen for any exhaust leaks. Once no leak has been determined, Place car back on the ground and go for test drive. Check engine light should go off after three start up and car has reached it's operating temperature and DTC codes will be erased after 100start cycle. Good luck and be safe.

Posted on Jan 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse box on a saturn ion 2003 located


On this website you find fuse box diagram diagram and description for Saturn ION (2003)

Saturn ION 2003 2004 fuse box diagram Auto Genius

Sep 04, 2013 | 2003 Saturn ION

1 Answer

The Saturn Ion randomly will not start. The starter will not rotate all the way, then the security light turns on. I have to weight at least 5 min then it might start just fine or start up for a second...


Something to do with the PASSLOCK system - anti-theft . Loose passlock sensor or key . Thing's do wear out after time . The passlock sensor is part of the ignition lock cylinder housing .There is also a magnet in the lock cylinder an when you turn the key the magnet rotates past the sensor causing a voltage signal that the module in charge (BCM) reads ,worn or sloppy fitting parts are probably the problem . Your vehicle is 14 years old , just think of how many times the key was stuck into the ignition switch an turned . Don't know of any by-pass fixes for this , look on line . Or you probably would have to replace the whole lock an lock cylinder .

Aug 22, 2017 | 2003 Saturn ION

1 Answer

We have replaced the ignition switch in our 2003 saturn ion. How do we reset the passlock?


Leave the key in the on position for 10 minutes until the security light stops flashing. Turn the key off and wait 5 sec. If it starts and dies, leave the key on for 10 min. again. You might have to leave the key on 3 times. While you are doing this have a battery charger on it. If the battery goes dead. (You might have the key on for 30 min if you have to do it 3 times the battery might get low) you will have to start all over.

Nov 09, 2010 | 2003 Saturn ION

1 Answer

2003 saturn has engine light it starts fine drove to store wont restart shows a lock in the dash board after about 15 minutes it started and was able to get home any idea what is wrong and will this happen...


The passlock sensor in the ignition switch which reads your key as it is turned and sends that data to the Body Control Module did not read your key properly. Now it depends on model of Saturn you have. The Saturn Ion could have a bad ignition switch, but the Saturn L-Series could have a bad ignition housing. The Ion's are notorious for having an ignition switch issue which will cause the car not to start.

Please let me know if you need anymore info.

May 27, 2010 | 2003 Saturn L-Series

1 Answer

Oxygen sensor location on a 2003 Saturn Ion-1


One is front of the cat, and one after the cat of the exhaust.
The OBD Scanner should tell you which bank is producing the error.
Bank one is the front one.

Thanks for using FixYa - a FixYa rating is appreciated!!

Feb 21, 2009 | 2003 Saturn ION

3 Answers

2003 Saturn Ion will not start. Security lock is on.


The fix for this problem is well known, so is the cause. GM needs to step up in my opinion. You can fix it yourself if you're willing

http://moontaj.com/passlock

Dec 23, 2008 | 2003 Saturn ION

Not finding what you are looking for?
2003 Saturn ION Logo

Related Topics:

638 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...