Question about 1994 Toyota Camry

1 Answer

Oil leaks from oil pressure switch on 5.2 liter engine in 1994 jeep grand cherokee. Need instruction for location and replacement in vehicle.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Toyota Master
  • 1,075 Answers

Lets step back and take a look at what your are saying?so you have an oil leak from the oil pressure switch, and you ask me for instructions to the location?then you want to replace the vehicale?????? sory im lost .adrian,,,

Posted on Aug 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I cant find the oil pressure switch


What engine? 4.7 liter it's right above the oil filter. Typically oil pressure sensors/switches are close to the oil filter on most vehicles.

Aug 07, 2012 | 2002 Jeep Grand Cherokee

1 Answer

Oil leaks from oil pressure sending unit on my 1994 jeep grand cherokee limited v8 5.2 liter


Replace it immediately the leak will only get worse. On some, you may need a sending unit socket, unless it has flat sides that will work with a wrench. Wrap the thread with teflon tape (one turn) to prevent it from leaking there and do not over-tighten or it will snap off.

Jul 05, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Need to know the plugwire placement in 1994 Jeep Cherokee


That vehicle came with three different engine options for that year, there was a 2.5 liter inline 4 cylinder engine, a 4.0 liter inline 6 cylinder engine, or a 5.2 liter V-8 engine. Here are the firing order diagrams for all three engines and one of them should help you to solve your problem.


2.5 liter.

d67d0f0.gif



4.0 liter.

05d66f8.gif



5.2 liter.


b03154b.gif

Jun 13, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Where is the oil pressure sending unit located on a 2000 jeep grand cherokee 4.0 liter


Removal & Installation
  1. Disconnect the negative cable from the battery.
  2. Raise vehicle on hoist.
  3. Remove front splash shield.
  4. Disconnect oil pressure sender connector (4).
  5. Remove the pressure sender (2).
6eaedba.gif
Oil pressure sending unit


To install:
  1. Install oil pressure sender.
  2. Connect oil pressure sender wire.
  3. Install front splash shield.
  4. Lower vehicle.
  5. Connect the negative battery cable.

Jan 12, 2010 | 2000 Jeep Grand Cherokee

2 Answers

Would a bad Oil Pressure Switch jeep grand


it certainly can .......... the switch is cheap enough to replace too

Nov 14, 2009 | 1993 Jeep Grand Cherokee

1 Answer

2002 Grand Cherokee--oil pressure indicator stays between 7/8 and full High. Is this cause for concern?


no shouldn't I garentee the problem is with the oil presure switch. if it is a 4 liter it is located on the passenger side on the block with a green connector on it. If it is a 4.7 it is located on top of the oil filter. The switches are very cheep about 10 bucks I would replace it if the vehicle has high mileage.

Sep 29, 2009 | 2002 Jeep Grand Cherokee

2 Answers

Oil leak, 5 quarts in 75 miles. Somewhere to the rear of the filter, filter OK


Hello thundergod: My name is Roger and I will answer your question.Their is a oil pressure switch located to the rear of the oil filter. Should have a shield over the terminal. When this switch ruptures you will have a large oil leak. If you unplug the switch and start the engine you will see the switch leak. If you have a gauge it is called a sender unit. If you have a light on the dash it is called a pressure switch. Please rate the quality of this answer as this is how we know you received the right answer. Thank You for using FixYa.Roger

May 16, 2009 | 1995 Jeep Grand Cherokee

2 Answers

Oil leak from sensor


It's called an oil pressure sending unit. There are two versions one for vehicles with a light on dash, one for those with a gauge. It's not expensive and MUST be replaced. Not hard to do.

May 11, 2009 | 1994 Jeep Grand Cherokee

1 Answer

How to replace oil pressure sensor


its on the rear of the engine next to the distributor

Dec 03, 2008 | 2002 Jeep Grand Cherokee

Not finding what you are looking for?
1994 Toyota Camry Logo

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...