Question about Mercedes-Benz 190-Class

Open Question

Make mercedes model actros 4143 manufacture 2001 problem 1. truck driven on 1 gear till 3 lo gear at full acceleration pedal revs up to 2300 rpm and from 3 hi onwards till 8 hi at full acceleration pedal revs till 2100 rpm. problem 2. this truck has a mounted crane and when operating the crane by pressing it's levers for movent it doesn't acclerate revs it remains idle speed at 600 rpm.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 32 Answers

SOURCE: Mercedes C200 just idling accelerator does not work

Try this. Turn the ignition to position 2 and leave it about two minutes(you should hear components moving/making noise under the hood). This should relearn the throttle stop(sounds like your vehicle lost synchronization). After that period of time, start the car and see if it helps. If not, then it will probably have to go to the dealer so they can use the computer to try and relearn it.

Posted on Nov 14, 2008

Ad
  • 43 Answers

SOURCE: Truck idles rough but at

Give it a complete tune-up, New spark plug and wire.new Ignition coil. Depending on the engine either replace ,Cap and rotors or coil packs.Also might want to get the fuel injectors service

Posted on Nov 17, 2008

  • 1 Answer

SOURCE: hesitation during acceleration

could be the type of plug you are using.I was told only to use ngk plugs.I recently put bosch plugs in my mazda 3 and the check engine light came on and it started missfiring.

Posted on May 03, 2009

Bob Gemmell
  • 209 Answers

SOURCE: No power, no acceleration, spits & sputters

If this is a diesel replace the fuel filter

Posted on May 29, 2009

  • 295 Answers

SOURCE: 2001 Yukon XL SLT 4 speed Auto Transmission shift problem!

Sam,

I would start with a transmission fliud and filter service.

I would then have the trasnmission checked out by a transmission shop. The transmission most of the time has the direct drum band is starting to go. The shops can rebuild it no problem, This is a very common failure wiith the trasnmission.

Good Luck

Posted on Aug 16, 2009

Testimonial: "Thanks alot richtko94'! I'll try that!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On Mercedes Actros 1841 (2008 year of manufacturing) parking brake light blinking (on and off) even parking brake is not applied and truck is driven. What will be problem and solution?


check for loose connections or wire grounding out near the park brake switch
as it should be air controlled spring brakes for the park brakes check for a problem air switch in the park brake air lines

Oct 21, 2016 | Mercedes-Benz Cars & Trucks

Tip

MERCEDES BENZ ACTROS,ATEGO,AXOR TRUCK FULL FAULT CODES LIST


MERCEDES BENZ ACTROS,ATEGO ,AXOR TRUCK FULL FAULT CODES LIST

5 Pages

Source
TRUCK Tractor MANUALS PDF

on Dec 20, 2016 | Cars & Trucks

2 Answers

Have a 4M41 engine in the 2007 mitsubishi triton and when under acceleration between 2000 - 2600 rpm the engine hunts or surges and then clears after 2600 rpm. It is more noticeable in 3/4/5 gears only...


It needs a programming check of the accelerator pedal via ecu of the engine. All previous activity of the system is recorded in the ecu which can be corrected in the dealership of mitsubishi.

Mar 28, 2011 | 2001 Mitsubishi Montero

1 Answer

DEFINITE LURCH IN 1ST AND 2ND GEAR,


This may apply. ...............................

Carry out the adaptation drive cycle road test:

Note: This process must be carried out in normal mode (not sports mode). On a flat road, the transmission fluid temperature must be above 60° C (140° f) and below 100° C (212° f) (vehicle at normal operating temperature will ensure that the transmission fluid temperature is above 60° C (140° f)).
9. Accelerate from rest with light throttle (do not exceed the upper rev limit in appendix 1). 1-2, 2-3, 3-4 shifts must occur with engine speed between the following limits:.
Note: Do not move the accelerator pedal during shifts.

• 3.0L VIN ALL 1800 - 2000 rpm
• 4.2L N/A Prior VIN M96321 1450 - 1600 rpm
• 4.2L N/A From VIN M963221550 - 1700 rpm

10. Continue to accelerate gently to 50 mph (80 km/h) so that transmission shifts into 5th gear.
11. Go into overrun and let the transmission shift down into 4th gear without braking.
12. Brake gently to a standstill and hold footbrake on for at least 15 seconds.
13. This process should be carried out at least five times.

Page 2 of 3 Bulletin Number S307-17
________________________________________________________________________________

Jan 17, 2011 | Jaguar S-Type Cars & Trucks

4 Answers

How to do a minor learning process to an actros


Minor:
press clutch pedal
press the N switch & keep pressed
switch on ignition you will hear sound or the N will display
release clutch the sound or the N
press clutch hear the sound
release clutch
end

Jun 30, 2010 | Mercedes-Benz Mercedes Bentz Actros Semi...

1 Answer

Automatic 330i 2001, if i start accelarating at 3rd gear the RPM keep increaing and if i release the gas the car should change to next gear but i does not...at low RPMs it is working fine


the gearbox is a "fuzzy logic"system.gearchange depends on accelerator pedal position/revs/load.if you drive without depressing the gas peddle more than a third down you should find all gearchanges much smoother.(if you drive with gas peddle almost hard down all the time yhe car will hold gears longer...poss 4500 revs or more......

Feb 23, 2010 | 2001 BMW 330

3 Answers

Where is located brake light switch on actros 1840?


Hi:
Most brake light switches are mounted to the upper area of the brake pedal arm, and are held in place with a pin or clip.

Dec 12, 2009 | Mercedes-Benz Mercedes Bentz Actros Semi...

1 Answer

2003 rio 1.3,car stuttering at take off,at full


If this an automatic replace your throttle cable located in the same place with that of the accelerator cable. Keep me posted.

Nov 29, 2009 | 2003 Kia Rio

1 Answer

Engine over-run between gears


This is a very common problem for ford. I have the same thing every day. It is the computer not reading the temp. When it does that just tap the gas pedal.

Jul 19, 2009 | 1992 Ford Escort 4 Door

1 Answer

2000 Volvo S40


one unit that operates ratio changes and is connected to the engine is that vacuum operated actuator on the transmission
it is possible that that unit is failing , vacuum hose is leaking and that will cause ratio changes as the vacuum varies
run the fault codes to check for wiring problems or VSS or TCM problems as well

Mar 23, 2017 | 2001 Volvo S40

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...