Question about 1997 Chevrolet Blazer

Open Question

Removing and replacing the starter on a 1997 Chevy Blazer

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76846 Answers

SOURCE: 97 chevy blazer

There are no free full diagrams on the net, you need to charge and test the battery, clean the battery cables and run a voltage drop test as well, replace them if the are badly corroded. Kragen will test the battery for free.

Posted on Aug 31, 2008

Ad
bryant329
  • 125 Answers

SOURCE: 1999 Chevy Blazer Starter

the starter is located on the passenger side lower motor. it has two bolts in it that hold it in place. it actually goes through a hole/slot in the transmission to the flex plate.

1st. disconnect the negative cable on the battery.
2nd. raise the vehicle safely and place a jack stand under the vehicle out of your way but near where you will be working(for safety).
3rd. remove the two bolts that hold the starter in place.
4th. remove the wires from the back of the starter.
5th. install in reverse order of above.

note: there may be little plates between the starter and the mounting points called shims. if there are then make sure you put them back.

Posted on Sep 24, 2008

  • 5 Answers

SOURCE: 2000 Chevy Blazer

i am working on a s 10 of the same yaer and problem i will post my results after tomorrow when i have finished the job i bout this truck cause of the forum i own one that is a great one and this one is for experimental purpose i will let u know so far you cant lift the motor with a jack or a hoist so we r going another route in the mornin

Posted on Dec 27, 2008

  • 47 Answers

SOURCE: need to replace rear brakes on 1997 chevy blazer

disk or drum?

Posted on Jun 23, 2009

nvannoy
  • 234 Answers

SOURCE: How do I replace my starter?

Open hood.
Disconnect negative (-) batter cable
Locate the starter (under vehicle).
Remove electrical connections. (be sure to remember/take a picture/ make a drawing/ or mark which wires go to what posts)
Remove mounting bolts.
Remove starter, replace with new starter
Install mounting bolts
Install electrical connections

Posted on Jan 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I'M WORKING ON A1997 CHEVY BLAZER THE FUEL PUMP WENT OUT AND WAS REPLACED WILL START SOME TIMES REPLACED RELAY DIDN'T FIX IT WHEN IT WILL START THE WORNING LIGHTS ON THE DASH WILL COME ON WHEN


Check the engine bulkhead main wiring connector in front of the driver on the firewall, see if it is loose or corroded, remove it and reinstall it. This can also be due to the ignition starter switch being defective on the rear of the ignition key cylinder, very common on this model..

Oct 02, 2012 | 1997 Chevrolet Blazer

2 Answers

How do I take a starter off 1997 chevy blazer?


I had to take motor mount loose on that side & lift motor away from mount to get room to remove starter

Apr 01, 2011 | 1997 Chevrolet Blazer

1 Answer

It is a 1997 Chevy Blazer. I looked under the hood their is no fuse box for a starter relay fuse. I am trying to figure out where it is located. The starter works but the car won't start. We replaced the...


IF THE MOTOR WILL START WHEN YOU JUMP START, THE BATTERY IN THE BLAZER MUST BE LOW. USE A D.C. VOLTMETER, THE VOLTAGE AT THE BATTERY WITHOUT JUMPER CABLES, SHOULD NOT DROP BELOW 9 VOLTS WHEN THE STARTER IS TURNING. THERE IS A CRANK FUSE IN THE INTERIOR FUSEBOX. & A STARTER RELAY UNDER THE HOOD. BUT IF THE STARTER IS TURNING, THOSE ITEMS ARE WORKING. THEY ARE ONLY TO MAKE THE STARTER TURN. GOOD LUCK, DRVOLT.

Jan 27, 2011 | 1997 Chevrolet Blazer

1 Answer

I think the starter in my 1997 chevy blazer is bad. when i try to turn it over it tries to start for just a second, but then stops and begins to click. i used to have a problem with my battery posts...


Try removing the battery cables and boost the vehicle with another. If it starts, replace the battery. If it doesn't start check for any loose connections at starter and for power at starter. If you have power, remove starter and have it checked and replace if necessary.

Sep 08, 2010 | 1997 Chevrolet Blazer

1 Answer

How do I replace my starter?


Open hood.
Disconnect negative (-) batter cable
Locate the starter (under vehicle).
Remove electrical connections. (be sure to remember/take a picture/ make a drawing/ or mark which wires go to what posts)
Remove mounting bolts.
Remove starter, replace with new starter
Install mounting bolts
Install electrical connections

Jan 06, 2010 | 1990 Chevrolet S-10 Blazer

1 Answer

How much would a starter for a 1997 Chevy Blazer


If you are replacing it yourself, the factory starter is $167. The range for aftermarket starters is between $90 and $170, plus the core charge. If you are going to have a shop do it, they have no right to charge more than one hour labor for this. Starter replacement is one of the easiest of the repairs. You disconnect your battery, detach the cable on the starter, remove the bolts holding it in and pull it out. The new one goes in in the reverse order.

i hope this helps
-matthew

Oct 26, 2009 | 1997 Chevrolet Blazer

1 Answer

1997 Chevy Blazer wont start without starter fluid


Check fuel pressure it could be low regulator pressure

Jun 28, 2009 | 1997 Chevrolet Blazer

1 Answer

1992 Chevy Blazer Tahoe Starter Removal 4.3l 4WD Vortec


you have to remove the cover over the torque converter 4 bolts holds this on .you may be able to just move it out of the way. and yes it does sound like a starter problem.i hope this helps

Feb 22, 2009 | 1997 Chevrolet Tahoe

1 Answer

97 chevy blazer


There are no free full diagrams on the net, you need to charge and test the battery, clean the battery cables and run a voltage drop test as well, replace them if the are badly corroded. Kragen will test the battery for free.

Aug 31, 2008 | 1997 Chevrolet Blazer

1 Answer

Wireing on starter, 1997 chevy blazer 4x4.


this just jumps to the other large post (battery power) on the starter -jeff please rate

Jun 30, 2008 | 1997 Chevrolet Blazer

Not finding what you are looking for?
1997 Chevrolet Blazer Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...