Question about 1995 Buick Century

1 Answer

What are the torque settings for mounting an automobile air conditioner compressor on a 1995 buick century with a 3.1 engine

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Buick Master
  • 1,871 Answers

Hello! Install bolts...Tighten front bolts to 37' #'s...Rear bolts to 22' #'s...Attach compressor hose and tighten bolts to 24' #'s........


I’m happy to help further over the phone at

Posted on Aug 06, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Location of fuel pump relay 1995 buick century

under the hood,passenger side, front of engine, passenger side of radiator,mounted on the relay panel (4or5 boxes) look for a long black thing and pull down on it, it take a #15 fuse. The fuel pump relay should be located here also.

Sep 01, 2014 | 1995 Buick Century

1 Answer

1995 Buick Century blowing hot air.

A mechanic would check the system with a set of pressure gauges. If the compressor is running, the low side would read around 30psi and the high side would be around 250psi. That is how you know if the system is full of freon or not.
You may have to get a professional diagnosis to proceed. If you replace the compressor, the accumulator needs to be replaced and a vac pump is used to pull all of the air out before the freon is added.

May 07, 2013 | 1995 Buick Century

1 Answer

Problem with heating and air conditioning. The driver's side is blowing hot air and the passenger side is blowing cold air

Air Conditioner blows warm air
  1. Air conditioner system is discharged. Have the system evacuated, charged and leak tested by an MVAC certified technician, utilizing approved recovery/recycling equipment. Repair as necessary.
  2. Air conditioner compressor clutch not engaging. Check compressor clutch wiring, electrical connections and compressor clutch, and repair or replace as necessary.

Jun 01, 2011 | 2004 Buick Century

1 Answer

I am looking for the port to charge the air 1995 buick century

look in the center of the firewall behind the engine for a black cap that looks like a tire valve stem cap ,......only larger

Jul 13, 2010 | 1995 Buick Century

1 Answer

Trying to find out where my compressor is

Take your pick since I don't know your engine size:

A/C compressor mounting-2.2L engine

A/C compressor and bracket removal and installation-2.3L engine

A/C compressor mounting-2.5L engine

A/C compressor and bracket-2.8L and early 3.1L engines

May 24, 2010 | 1995 Buick Regal

2 Answers

How easy is it to change glow plugs in a 1995 (N reg) discovery?

should be handy enough just screw out put new one in
if your machine hard to start when heating in the morning ,wait twenty seconds after light goes out then crank it
heater relay still working when heat indicator light goes out

Feb 25, 2010 | 1995 Land Rover Discovery

1 Answer

How to remove and replace 99 buick century heating and air-conditioning resister board

Usually inserted into the heater air duct. Either in the engine compartment on the passengers side or behind the glove box. Has a 3 or 4 terminal connector and it's mounted by 2 screws

Feb 07, 2010 | 1999 Buick Century

2 Answers

How do i change the starter on a 96 century

If it's the 3.1 or the newer 3100 the starter should just be a couple 13 and 15mm bolts. Plus the nut for the cable. Hope this helps.

Jul 13, 2009 | 1996 Buick Century

1 Answer

Where is the Cam Sensor located on a 1995 Buick Century 6cyl engine? Is it accessible for replacement?

Under hood, passenger side, lower engine area, above and behind crankshaft pulley, mounted on engine block.

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Jul 01, 2009 | 1995 Buick Century

Not finding what you are looking for?
1995 Buick Century Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides