Question about 1994 Chevrolet S-10

1 Answer

94 Chevy S10, 4.3L V6 Auto. Trans. It wont start. The engine turns over and it's enough air and fuel so I've determined that it's and electrical problem. I've replaced the battery and the ignition coil. The distributor cap, plug wires and spark plugs are fine. The alternator is probably bad but I can't figure that out until the engine is running. Maybe the distributor itself is bad? I'm not sure. Any advice?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 835 Answers

Could module iin the dist.

Posted on Oct 28, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my 1992 4runner die when I put it in gear?


that could be an air/fuel problem ,does the engine rev ok when not in gear ? if it does then probably not air/fuel. the autobox speed sensor might be the fault have it checked at a auto trans repair shop

May 11, 2014 | 1992 Toyota 4Runner

1 Answer

94 jeep grand cherokee ltd 5.2l, wont start, turns over, smells like fresh fuel, has backfired from exhaust, replaced spark plugs (fuel fouled and dirty) and has worked for about a week and gradually...


You are saying the injectors are allowing too much fuel into the cylinders. Or not enough air from the air filter.
Is the check engine light on, and have you checked the fuel pressure regulator ?

Jan 15, 2014 | 1994 Jeep Grand Cherokee

1 Answer

94 chevy s10 4.3 engine wont start but it will turn over has fuel pressure and when you spray a little gas in the intake it cranks up but then stops


fuel starvation ie blocked filter /blocked pipe / as no fuel is reaching the cylinders
BUT FUEL IN INTACE AND STARTS BUT WONT RUN THIS IS BECAUSE THE FUEL BURNS AND STARTS THE ENGINE THEN STALLS AS NO FUEL CHECK ALL FUEL FILTERS AND FUEL LINE FIRST CHEAPEST OPTION

Aug 17, 2012 | Chevrolet Chevy Cars & Trucks

1 Answer

94 gmc sierra 4.3 v6 manual, won't turn over, can hear fuel pump start when accessories turned on..won't fire, girl who needs help


The first thing I would check is fuel pressure. This type of fuel injection requires a minimum fuel pressure in order to operate. If fuel pressure is as little as one psi below minimum the vehicle will not start. You can try squirting a couple of shots of carb spray into the air snorkel while somebody cranks the engine over. If the engine starts and then dies you now you fpdeffinetely have a fuel issue. If the engine still won't start check for spark. Let me know what you find. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Feb 07, 2012 | GMC Sierra Cars & Trucks

2 Answers

2001 GMC Jimmy with a 4.3L V6 auto trans. Will not turn over


The starter relay may have a bad connection, this is where your battery connects, and a power wire runs to the starter, also these have a ignition wire which is approx 14-16 gauge wire. The relay could be cracked or the contacts inside are going bad. But the other is the neutral safety switch that you mention. I would check these first.

Apr 08, 2010 | 2001 GMC Jimmy

1 Answer

94 pathfinder v6 auto 4x4 .engine died nuw wont start ,turns over and tries to fire,maybe the timing belt broke?if so would the valve train be damaged Thanks Barry


This vehicle has an interference engine (v6-VG30E), If the timing belt ran or snapped while running, its very possible the engine is severely damaged. Hopefully this helps!!

Mar 28, 2010 | 1997 Nissan Pathfinder

1 Answer

Truck getting too much gas. 94 GMC Sonoma. V6 engine. Black smoke out exaust. Plugs keep fouling out. I Changed everything fuel related plus computer under dash board. Truck not starting now. HELP.


Did you check sensors such as crank senors? cam sensor? knock sensor? or mass air flow? Could all be causing it to get to much fuel. Just had same problem on 1997 Chevy Lumina

Jul 03, 2009 | 1994 GMC Sonoma

3 Answers

Slipping auto trans in 94 chevy truck


actually i would say no because there are 6 cyl transmissions with 4 frction plates and v8's have 5 friction plates in the forward planetary gear

Mar 27, 2009 | 1994 Chevrolet C1500

1 Answer

94 celica starting problem


check your engine timing

Feb 16, 2009 | 2000 Toyota Celica

Not finding what you are looking for?
1994 Chevrolet S-10 Logo

337 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...