Question about 2004 Chevrolet Colorado

Open Question

How do i remove the intake on a 2004 chevrolet colorado 2.8 l

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 141 Answers

SOURCE: replacing rotors on a 2004 chevrolet colorado

hub and rotor should be two pieces....Lee

Posted on Nov 06, 2009

  • 33 Answers

SOURCE: cannot get the hub off to replace rotors

the rotors should be on the hub behind the wheel... you will have to remove the brake caliper and it should just pull off... may be a few clips on the wheel stud

Posted on Nov 06, 2009

GM Elec
  • 1000 Answers

SOURCE: How do I repair a radiator leak on my 2004

It really depends on where the leak is. If it is leaking in the radiator core, a can of Bars Leak will take care of it for a while. If the leak is in the side tanks there is a product made by Permatex called fuel tank and radiator repair kit that works very well. Both of the products can be found at your local Auto Zone parts store.
Good luck.

Posted on Nov 17, 2009

  • 57 Answers

SOURCE: 2004 chevrolet colorado - is

need new plug wires and spark plugs

Posted on Mar 01, 2011

  • 1249 Answers

SOURCE: My 2004 chevrolet colorado is chokin when i stop.

Sounds more like the Idle/Air Control valve...(may be just dirty) you can remove to clean...(with spray cleaner) or replace as needed. This part is about $ can have the plug wires tested for resistance at your Auto Zone store...could always use new plugs depending on mileage...Hope this helps.

Posted on Oct 03, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Location of evap purge valve solenoid on a 2004 chevy Colorado z71 4x4 3.5l looking from the front of truck

. .It's on the side of the engine under intake manifold in the middle between the starter and the alternator .

Evaporative Emission (EVAP) Canister Purge Solenoid
Left side of the engine below the intake in back of the alternator

Dec 31, 2016 | 2004 Chevrolet Colorado

1 Answer

2006 chevy colorado fuel system diagram I need help diagnosing the problem of the gas smell coming from my truck. No leaks...but a very strong gasoline smell...please help me out!

The Chilton/Haynes repair manual we got for our 2004 Trailblazer has a fuel diagram. So I believe the same type manual for your Colorado should be no different as to information. Did find in research that there are plastic parts on the fuel lines that run under the air intake. Over time they become brittle due to engine heat since they are on top of engine but under the plastic air tube and are prone to leak over time. Not hard to fix, just a pain to remove the interfering parts.

Aug 26, 2016 | 2006 Chevrolet Colorado

1 Answer

Water in oil 2004 colorado

Sounds like head gasket blowen betwin oil galley they can blow 3 or 4 different places intake, oilside ,axhaust.

Mar 23, 2013 | 2004 Chevrolet Colorado

1 Answer

How to remove front brake rotor on 2004 chevrolet colorado

Time to sell the truck. Truck was not designed to be user serviceable.

Jul 17, 2012 | 2004 Chevrolet Colorado

1 Answer

Wan't to buy a used colorado auto 5 cyl. Wanted to know if a 2004 was worth buying. Thanks. Tom

Click on the link below to read up on consumer guides review of the 2004 Chevrolet Colorado. Based on a rating of 40 out of 100, I would shop around and look at other trucks before you decide to go out and buy this one:

Feb 04, 2011 | 2004 Chevrolet Colorado

2 Answers

Low idle on chevy colorado

The best thing to do is run a trouble code check on it.
Other than that check for a vaccum leak, the EGR valve, or the idle air control valve.

Dec 30, 2009 | 2004 Chevrolet Colorado

1 Answer

Cannot get the hub off to replace rotors on the 2004 chevrolet colorado the rotors are behind the wheel hub need to remove hub to replace the rotors is there someway to remove the hub

the rotors should be on the hub behind the wheel... you will have to remove the brake caliper and it should just pull off... may be a few clips on the wheel stud

Nov 06, 2009 | 2004 Chevrolet Colorado

1 Answer

Intake manifold cover

remove oil cap steam an it should just lift off

Feb 23, 2009 | 2005 Chevrolet Colorado

1 Answer

Vacuum leak

plastic cover must come off to repair hose< hope you have a garage friend he will help you if not post it again i will ask my mechinic.

Feb 22, 2009 | 2004 Chevrolet Colorado

Not finding what you are looking for?
2004 Chevrolet Colorado Logo

Related Topics:

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

81294 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides