Question about Toyota Pickup

2 Answers

When I turn my ignition switch my stater turn the engine over the truck starts when i let go of the key the engine stops. each time I try starting it up I get the same results. Is it a bad switch.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 327 Answers

It sure is its in the steering column on the back of the key switch

Posted on Aug 06, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,092 Answers

Yes, replace ignition switch, contact's in switch are bad, replace it you'll be fine.

Posted on Aug 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Starter is loose


I don't understand what you are trying to say. If the key turns all the way to start and nothing happens, you probably have an ignition switch failure

Jan 19, 2013 | 1997 Ford Crown Victoria

1 Answer

Car would not start when i turn the key . sometimes a hear a click which could be the solenoid. other time i hear no click, it starts after i turn the the key lots of time . the ignition is ok. Could


check for lose wire connection off wires on solinoid and battery solinoid is connected on stater motor normally on the side off engine at the back off engine

Dec 09, 2012 | 2005 Hyundai Elantra

1 Answer

When i turn the key to start the engine, the key must be turned off & on a few times before the starter is engaged, why?


There is a poor contact on the wire terminals on your ignition switch, have that changed. Check also stater solenoid.

Feb 28, 2011 | 1995 Volkswagen Passat

2 Answers

Turned key to start engine, battery was low engine only cranked three times. Turned key to off but engine was still trying to crank with the key in off position. put on battery charger and engine tried to...


stater bendex/new starter.or relay.but start with new starter.PS make sure your cables are clean AND THE BSTTREY IS HOT.a low or bad batt can do the same thihg

Nov 21, 2009 | 1995 Dodge Ram

2 Answers

Pt wont start or turn over


try to get a jump from a friend and see what happens, does the same, faulty starter, may need replacing, try to use small hammer and tap lightly on the starter couple time and have a friend start the car while you tap lightly on it. check ignition switch where you stick the key in. stick the key in the ignition and turn the key back and forth jiggle and wiggle it and see if your igniting will make contact. do it several time to test and see if its the ignition problems, this part is not cheap to replace.

Sep 25, 2009 | 2004 Chrysler PT Cruiser

3 Answers

Replaced ignition switch 2003 chevy impala and car will not start


After you replace the ignition switch turn the key to start the car and release leave the key were it stops after trying to start wait 10 minutes until security light goes out turn key to full off position then repeat the above procedure two more times for a total of three on the 3rd attempt to start car wait for light to go out then turn key to full off positoion wait 10 seconds then try to start car body control module should learn new pass code and the car should start.
Big john, J@J Automotive

Sep 15, 2009 | 1999 Chevrolet Lumina

1 Answer

Toyota starter problrm


NEED TO REPLACE STARTER.

Mar 03, 2009 | 1996 Toyota T100

2 Answers

1999 Toyota Corolla CE. For about 2 months, the engine does not start immediately. I need to turn the ignition key several times until it starts. Each time when I turn the key, a clicking sound happens...


it sounds like either your having a short at the starter or the ignition switch is bad, I am leaning towards the issue being the starter, usually when the ignition switch is going bad there will be no click,

Oct 06, 2008 | Toyota Corolla Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...