Question about 1994 Ford F150 Styleside Supercab

1 Answer

Is it hard to replace the y pipe on a 1994 ford f 150 4.9

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,092 Answers

NO, not that bad, if bolt's or nut's are hard to remove, worst case you'll need a torch to heat up the bolt, to remove are they might break.

Posted on Aug 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 1994 ford Taurus that has new plugs new thermastat new water pump new coil wires but car is still overheating


does putting heater on hot prduce hot air.on full with fan on does it reduce temo?is ur radiator fan coming on? hard to give one answer.as dont know if its overheating in traffic or on the move?there could be air stuck in pipes slowing water flow.or a pipe/radiator blockage so coolant doesnt get to flow around engine so it gets hot.u could check radiator by touching see if hot or cold where pipes enter(prob switch off engine first) try bleeding system squeesing pipes to push air out

May 20, 2015 | 1994 Ford Taurus

1 Answer

Can't find fuel pump relay on 1994 f-150 ford pick up


in the under hood fuse box on the left fender.

Jun 11, 2012 | Ford F-150 Cars & Trucks

1 Answer

Need free printable repair manual for a 1994 ford 150 xlt


i have a 1994 ford f150 it says its equiped with a reset switch for feul pump were is it at

Jan 31, 2012 | Ford F-150 Cars & Trucks

1 Answer

I have an 88 Ford F-150. There is a pipe that


I believe you are talking about the downstream tube. It has a check valve at the top that connects to a rubber hose , and then goes down to the converters. If that is what you mean you should be able to get one at any after-market supply store, make sure you get the valve, and the small clamps needed to replace it. it will probably have to be torched off at the bottom near converters.. Hope this helps. :-) Also make sure the head-to-head tube isn't rotted. It runs from one head to the other at the rear of the heads. ;-) Cobra

Jul 07, 2010 | 1988 Ford F 150

1 Answer

How to replace co2 sensor in ford econoline


to replace the o2 sensor from under truck follow exhaust pipe from engine towards rear of truck before cat converter will see on the top side a round short cylinder with a wire connection screwed into top side of exhaust pipe

Jun 22, 2010 | 1994 Ford Econoline

1 Answer

I am having issues getting my 1994 Ford Econoline Van to start. I have replaced the sparkplugs and the starter is ok. I have also checked the fuel pump and it is normal. could the issue be with the ecu?


Could be an air fault aswell, not getting enough or maybe to much air to start check all your pipes and air mass meter for any rips in pipes or a dirty sensor.

Could also be the crankshaft sensor.

Jan 22, 2010 | 1994 Ford Econoline

1 Answer

F 150 seems to be missing or something


fuel pumps also cause this issue in ford trucks

Aug 05, 2009 | 1994 Ford F150 Styleside Supercab

1 Answer

Can 1985 f-150 tailgate fit on a 1990 f-150


Probably will. The models really changed significantly in 1993. Models for 1984 to 1992 were pretty much the same. Suggest you measure everything on both to make sure. They are not hard to remover/replace.

Jul 09, 2009 | 1990 Ford F150

1 Answer

1994 Ford F-150: third brakelight


you have to peel the molding away from the truck on the outside and then change it then remold it

May 24, 2008 | 1994 Ford F150 Styleside Supercab

Not finding what you are looking for?
1994 Ford F150 Styleside Supercab Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...