Question about 2006 Chrysler 300

Open Question

I have a 06'Chrysler 300 and the check engine light came on so I took it to Advance Auto to check it. And it reads the coolant sensor is bad O.K changed it got the light reset now the light is back on with the Electronic Throttle Light

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 76846 Answers

SOURCE: need location of coolant sensor on 2002 chrysler 300m

near the thermostat I think, look for this part.


Posted on Apr 22, 2009

  • 76846 Answers

SOURCE: when should I get my fuel injection serviced on

unless the car has a symptom of a dirty injector there is no service required.

Posted on Nov 06, 2009

Testimonial: "That's good to know but how as a consumer would I know what the signs are?"

  • 248 Answers

SOURCE: I have '06 chrysler 300 i have problem with

unless you are messing up the alternator installations, then you have a bad short/ground in the head lites or starting circuit, most auto houses can tell you if your alt is charging, also when your battery is charged, unhook the neg cable- when you reinstall the cable check for excessive spark when the cable clamp touches the you have any aftermarket items that are not properly fused?...good luck to you hope this helps

Posted on Mar 08, 2010

  • 361 Answers

SOURCE: The paint on the hood of 06 Chrysler 300 peeling

U will find that this is a repair at some time. the mil thickness of the clear is to low and the uv light is breaking down the base coat causing the clear to peel and the elements to penatrate to the primer.
Probaly looking at $350 to $600 depending whether they blend the color on the fenders for a good match

Posted on Apr 14, 2010

  • 202 Answers

SOURCE: 1999 chrysler 300m shaft cam sensor is bad.

did you check the ASD relay,located under the hood in the fuse and relay box. hope this can help.

Posted on May 14, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2006 300c starts sluggish and won't stay cranked; then the red gas light and the engine light stayed on. Now it won't crank at all.

Could be many things. Best would be to read codes for a hint. Stuck EGR, leaky fuel injectors, bad fuel pump (test with pressure gauge), bad coolant temp sender, bad crank sensor, bad ignition module/coil, others also.

Dec 28, 2014 | 2006 Chrysler 300

1 Answer

Where is the oxygen sensor on a chrysler 300 2005

You will have to sign up as a forum member [free, quick and easy] in order to view the link to the online manual but I think you'll find what you need there-

Jan 15, 2014 | 2005 Chrysler 300

1 Answer

I took my car to be diagnosed on the computer and it read that my 2001 chyrsler 300 m engine coolant temperture sensor is bad i need a diagram of where it is located

go to the autozone website and find temperature sensors for your car, then you will know what they look like. then go to their parts locator and that will show you where they are on the car, most likely screwed into a head on the engine.

note it most likely screws in and touches the coolant. so when you take the old one out, coolant will be coming out the hole until you screw the new one in. be ready for this and make sure it is still not hot, note the threads may be a plumbing type tapered thread so do not screw it in like a bolt.

Aug 05, 2011 | 2001 Chrysler 300M

2 Answers

Yesterday my check engine light came on my 2002 Chrysler, oil level is good but i noticed the coolant is rust colored. Could that be the cause of the check engine light? Will a flush clear the light?

No a flush wont clear the light. Look at the coolant to see if it actually rust, some coolants are this color now. The light came on for an emissions problem. Could be as simple as you did get the gas cap tight enough. Have the codes read and let me know. Most autoparts store will read them for free. Don't buy something untill you check the part out. Like an 02 sensor code can be caused by a vacuum leak at the engine. The sensor isnt bad, the leak is letting in to much air to fuel and causing the sensor to pop a code.

Jul 19, 2011 | 2002 Chrysler Concorde

2 Answers

Car wont always start. idles high and wants to stall when taking off from a stop sign or traffic light. engine light stays on

you may have a bad idle control sensor. is your check engine light on? if so,then you can have it coderead at autozone or advance auto for free. but the check engine light has to be on in order to diagnose it,for free.thank you for choosing

Apr 14, 2011 | 1998 Saturn SL

1 Answer

2003 pt cruiser engine codes 0116 & 0522 came on... took it in for an oil change and everything was fine, engine light and codes are still there. I will unhook the neg. cable to reset but will the...

Most check engine lights will come on due to and emission problem. Stop by Advance Auto Parts and let them read the codes. It is probably a sensor.

Jan 18, 2011 | 2003 Chrysler PT Cruiser

2 Answers

Check engine light - P0420 code

Causes A code P0420 may mean that one or more of the following has happened:
  • Leaded fuel was used where unleaded was called for
  • An oxygen sensor is not reading (functioning) properly
  • The engine coolant temperature sensor is not working properly
  • Damaged or leaking exhaust manifold / catalytic converter / exhaust pipe
  • Retarded spark timing
  • The oxygen sensors in front and behind the converter are reporting too similar of readings

Please rate this solution thanks

Feb 02, 2009 | 2005 Toyota Corolla

1 Answer

Coolant sensor was replaced still get check engine light

If the code in the ecm isn't cleared then it will come back. Have them clear all codes and see if it persists.

Dec 09, 2008 | 2000 Lincoln Navigator

1 Answer

Check Engine Light on 2004 Envoy

Yes this definatly can damage your vehicle, it can cause your head gaskets to blow, you engine to stop running, and some cases you will have no heat, replace the thermastate right away.

Nov 20, 2008 | 2004 GMC Envoy

Not finding what you are looking for?
2006 Chrysler 300 Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8547 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides