Question about 1995 Dodge Neon

1 Answer

Is there any way you can put a timing belt on wrong because when they put my belt back on the car was running ruff like it didnt want to idle up

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 286 Answers

It is very possable to put it on wrong. If the timing is off by 1 tooth it wont run right.

Posted on Aug 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I recently have been having problems with my 2001 Ford Windstar shutting down when i go in reverse and it shuts down when i come to a stop. What could be wrong?


it could be a blocked fuel filter ,a bad idle solinoid , a week fuel pump, a bad throttle position sensor ,dirty air filter , If car is not running ruff before putting in gear . if running ruff all the time it could be bad plugs,injectors coils plug wires or any of the above. check for a vaccume leak it is a # 1 problem with windstars. if this was helpful please leave good feed back

Nov 29, 2014 | 2001 Ford Windstar

2 Answers

Ruff ideal ,no power,was told it could be a cam oxygen sensor or cam cylinoid any ideas?


rough idle can be the cam and crank sensor or the timing has shifted from weak timing belt/auto adjuster. also the idle valve on intake is sticking or and fuel pressure valve is not working properly if engine runs fine at speed then the adjuster on timing belt can be the fault, as the pressure on the engine turning the cams is putting the right pressure on the belt. if it is through the hole speed ranged the fuel pressure could be low. if engine goes in to limp mode or takes time to speed up it can be timiming alinment out and or the cam sesor or crank sensor.

Oct 15, 2013 | 2007 Mercedes-Benz C230 Sedan

2 Answers

Timing belt runs ruff. when it gets hot it stops


The ruff noise you have on the timing belt shows the belt quality,which is better to change the belt with a recommended by the manufacturer,for better results and more protection and safety.

Sep 14, 2012 | 1999 Mercury Villager

2 Answers

My lanos snapped its timing belt and i have replaced it but it is still running a little ruff its like its putting and verry sluggish


it sounds like the timing is off
when you replace a timing belt after it has snapped you risk internal engine damage-i would start by checking the timing-the belt may be on wrong-if that is not the problem you may be looking at a new engine

Feb 16, 2010 | 2000 Daewoo Lanos

2 Answers

Ruff idle and some times dies,computer says too lean


check for vac. leak or bad injector dumping fuel

Oct 27, 2009 | 2000 Nissan Sentra

2 Answers

1993 Mecury Capri Timing Belt? Fuel Injectors?


If the car was running great and then all of a sudden it started this problem and you did not change the timing belt. Then I would say its not your timing belt. Once a timing belt is on its stays timed until it breaks, unless it looses a tooth on the belt and at that point it would run really ruff all the time or not at all. If it cranks well and idles with a small skip but when you add gas it get worse. I would look at your fuel injectors and spark plugs and wires. start simple and work towards the big stuff. most of the time its simple like plugs and wires or gummed up injectors. Run some good injector cleaner as well. Hope this helps

Apr 04, 2009 | 1993 Mercury Capri

2 Answers

1991 deville idling very ruff


Hi you should change the coolant temp sensor this is a white sensor on top of the intake and is part ot the computer system.

Dec 30, 2008 | 1991 Cadillac DeVille

Not finding what you are looking for?
1995 Dodge Neon Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...