Question about 2000 Chrysler Town & Country
On the inside panel, there is a cap plug, pull it off. Look in the hole and see the linkage. Pry it up with a screw driver and it will unlatch. Take all the screws out and remove the panels. Oil all linkage joints and pivot points. I use 30wt in a squirt can. WD won't last. This worked great for me. Gary L "BOSSBLU"
Posted on Nov 22, 2010
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Apr 07, 2018 | Ford Cars & Trucks
Aug 24, 2017 | Cars & Trucks
An open or short to ground in the lift gate lock relay battery positive voltage circuit
A faulty lift gate lock relay
An open or short to ground in the lift gate lock relay control circuit
A short to ground in the lift gate lock actuator lock control circuit
A faulty BCM
May 14, 2016 | Cars & Trucks
Nov 25, 2012 | 2007 Lincoln MKX AWD
Jan 30, 2018 | 1996 Toyota 4Runner
To open the lift gate manually, use the door unlock switch located
on the drivers door. This should unlock the lift gate as well. Go to the lift
gate and lift the handle to open the rear gate.
Your power lift gate is computer controlled. Sometimes there will
be a faulty input sensor or part that will show the incorrect data to the computer,
therefore the computer will not go through its normal functions.
In most cases its the problem of lift gate latch assembly.
To get it tested and confirmed there is a troubleshoot guide
provided by the service center. To perform this troubleshooting guide you will
require a scan tool to diagnose the exact problem.
the troubleshooting procedure is as follows:---
Please use the following information below when diagnosing an inoperative
lift gate. Disconnect the connector at the lift
gate latch assembly. With the lift gate latch connector disconnected, the 3
signals for the ratchet, pawl, and the sector should be inactive on the scan
Install a 3A fused jumper wire between each signal circuit
terminal (for the pawl, sector, and ratchet) and the ground circuit terminal 2.
Monitor the scan tool as each individual circuit is jumped to ground, the scan
tool should read "active".
If either tests above fails, check the wiring for the signal
circuits, low reference circuit, or try a power lift gate control module from a known good vehicle. If both tests above pass, monitor the internal switch inputs in
the lift gate latch assembly for proper operation.
3. A) with the lift gate in the open position, the ratchet and the
pawl should read "active" and the sector should read
B) With the lift gate in the secondary latched position, the pawl
should read "Inactive" and the ratchet and sector should read
C) With the lift gate fully closed, the pawl, ratchet, and the
sector should all read "inactive".
4.If one of the internal lift gate latch assembly switch inputs
are not reading correctly in one of the positions above and the vehicles passes
test 1 and 2 above. Replace the lift gate latch assembly.
Please follow this diagnostic or repair process thoroughly and
complete each step. If the condition exhibited is resolved without completing
every step, the remaining steps do not need to be performed.
This should help you.Thanks.Helpmech.
Dec 04, 2010 | 2006 Cadillac SRX
Oct 15, 2009 | 1999 Jeep Grand Cherokee
Apr 23, 2009 | Jeep Grand Cherokee Cars & Trucks
130 people viewed this question
Usually answered in minutes!