Question about 1990 Toyota Celica

1 Answer

I have a 1990 toyota celica gts 2200 motor I have changed the wiring harness caujse it was burnt and after replacing it wouldn't idle so we replaced the computer still the same so replaced the tbi and throtle position sensor and a vacome line that was bad and now the car idles at 500 rpm and over fuels and misses and smokes I can't figure it out

Posted by on

  • shedevil7217 Aug 06, 2010

    Thank u we have replaced temp sensor with brand new one before the wire swap and ill try the map sensor thank you

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 462 Answers

If you replaced the whole engine wire harness,make sure all connectors are hooked up , if they ok ,check MAP sensor and temp. sensor .it might be your problem.If possible swap them with known good used ones, or just try to disconnect it and see if it runs any better.

Posted on Aug 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 toyota celica gts 2200 motor vibration when idled up


You may want to check your motor mounts. If the mounts are broken or just too old they will cause the engine to have excessive vibration your notice also when shifting to drive or reverse it will feel like the vehicle jumps. replacing the mounts will help if they are damaged or may be that the vehicle needs a tune up.

Nov 07, 2013 | 1990 Toyota Celica

2 Answers

1990 Toyota Celica will not start.


Sounds like the connection from the battery to the chassis ground is bad. Try replacing the Negative battery wire and make sure where it attaches to the frame is as rust free as possible

Dec 30, 2009 | 1990 Toyota Celica

1 Answer

I'm trying to clear codes for a 1990 Celica GTS. Any hints??


You might try removing the battery connectors for five minutes and replacing back.

If the codes do not disappear, please you might have to get a scanner to do that.

Cheers.

Oct 24, 2009 | 1990 Toyota Celica

2 Answers

1985 toyota celica gts idle when starting


it may be one of the water temp. sensors at the thermostat housing.

also check the plug, wires,distributer cap and rotor.

good luck

22re owner

Jun 24, 2009 | 1985 Toyota Celica

1 Answer

I have 1990 Celica GT 2200. no spark to plugs/power to fuel pump


need to change rotor and cap , and might as well change wires and spark plugs if its due for a tuneup! yeah have your ignition control module check if it doesn't start after replacing every thing else.

Jun 10, 2009 | 1990 Toyota Celica

1 Answer

1990 Toyota Celica GTS. Idle races too high


sound very much like a vacuum leak.... also maybe your timing is off? possibly advanced? try retarding it with the distributor if thats the case...

Jan 01, 2009 | 1990 Toyota Celica

1 Answer

1990 toyota celica gts electrical/transmission problem


strip out auto box and fit a manual gearbox ,this is an expensive repair by the sound of it,is it a manual pump in the box?? or has it had an electric one built in to keep the pressure up as i have seen this on *** cars ,good job not many autos in spain ,macho men here only old men from northern europe buy an auto and they are very expensive and difficult to get

Oct 08, 2008 | 1990 Toyota Celica

1 Answer

1985 convertible celica fuse location


Check the harness connections located inside r-rear trunk panel. You will find power top motor & wire harness there.

Jul 12, 2008 | 1985 Toyota Celica

Not finding what you are looking for?
1990 Toyota Celica Logo

Related Topics:

362 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...