Question about 1989 Acura Integra

1 Answer

Is driving with a squeaking throw out bearing ok?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 1,586 Answers

I wouldn't do so any longer than absolutely necessary.

Posted on Aug 06, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Nissan 1400 champ shakes the engine and cuts off on idling.when driving its making some sqicking noise and not accelarating

is it running the stock engine
or is something else in the engine bay

if still carby -- old school
check float and vacuum
timing and points gap

squeaking noise
water pump
drive belt loose or an alternator bearing
if manual gearbox
clutch throw out bearing



Dec 07, 2016 | Nissan Cars & Trucks

1 Answer

I have a Mazda 6 Sport 2009 and after about 15 mins driving I get a squeaking noise from the engine compartment every time I press the clutch. Anybody any ideas?

Throw-out bearing, clutch slave cylinder, clutch master cylinder, an angry mouse (probably not). Start with the first three. First, though, I would find an assistant who could help you narrow down where exactly the squeaking is coming from. One person presses on the clutch while the other listens in the engine compartment.

Jan 12, 2016 | Mazda Cars & Trucks

1 Answer

2003 chevy trailblazer motor knocking and throwing a small squeak

Henry, first need to determine if it's the actual engine that is knocking. Other accessories (water pump, steering pump, etc) could cause a knock. If the ECM knock sensor picks up a knock, regardless of where it originated from, will start to make timing and fuel adjustments which may cause it to hesitate or "sputter". You can take off the drive belt and start the engine. This will be the tale. If you hear the knocking, it's obviously in the engine and could be as bad as crank bearings or even the torque converter. Have you had any work done recently? If there is no knocking when the engine is running without the serpentine belt, you should now be able to narrow down the bad component by rotating each drive pulley until you find the damage..

Jan 16, 2014 | 1997 Toyota Tacoma

1 Answer

When im taking off slowly ther is squeak from front end sounds like squeaky fan belt but is coming from underneath cud it b clutch its ok when driving just there when i take off or driving slow . please...

it could be the clutch throw out bearing making the noise however it still could be a belt.check the condition of the belt and tightness of the belt(s) as well as the tensioner first as this is the cheapest to do if its the problem.the reason the noise goes away while driving is because the load(torque) on the component is less than when your taking off from a stop or driving slow.

Jul 06, 2011 | 2002 Lexus IS 300

1 Answer

When pressing in the clutch and releasing it there is a squeaking/whining noise that is being made. it shifts fine and i am not dropping out of gear, but I am worried about the noise. do you have any ideas...

start by spraying some WD-40 on the hinges of the clutch pedal. this will eliminate if the squeak is coming from the pedal and not the clutch. now assuming that it does not eliminate the squeak then here's the next thing.the throw-out bearing is beat. you can replace that on its own but if you are going to go through the trouble of replacing the bearing you might as well do the clutch too....

Apr 18, 2011 | Nissan Pathfinder Cars & Trucks

3 Answers

When I press the clutch in my 99 Rodeo, there is this horrible noise. What is the problem?

if the noise is only there when you push down the clutch, you need to replace the throw out bearing.

Apr 02, 2011 | Isuzu Rodeo Cars & Trucks

1 Answer

Had throw out bearing changed now it sounds like a growl coming from transmission and a squeak going down road.when u put clutch in all noises go away.

hate to give bad news but that is typical of a bad throw out bearing. either installed wrong or not at all. i would take it back. hope that helps please rate.

Nov 28, 2010 | 1991 Nissan Pickup

1 Answer

Ford focus 1800,tdi 2006 year.1000110 on the clock vibration on gear stick drives ok is it due a new clutch and how many parts is it 4parts required

3 new parts usaly, Clutch, Pressure plate, And throw out bearing, Sometimes a throw out bearing requires the slave cylender if so equipped

Jun 06, 2010 | 2005 Ford Focus

3 Answers

I have a 1999 Saturn SL 5 speed manual transmission. When I press on the clutch is squeaks. In the past I put some grease on the shaft above the clutch petal, it worked - now it doesn't. It also seems to...

check for leaks on master cylinder if you haft to add brake fluid its definately leaking,throw out bearing maybe going out?may of glazed pressure plate? good luck!!

Jun 21, 2009 | 1999 Saturn SL

2 Answers

Second tinme throw out bearing has to be replaced.

This is a weird one. Unless there is a TSB on bad bearings from the dealer, the only thing I could GUESS is a bad pressure plate, but you said you are replacing the whole thing.

Nov 22, 2008 | 2008 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts


Level 3 Expert

81424 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides