Question about Ford Crown Victoria

1 Answer

Dear Lady/sir, The radiator (closed system)was broken, a little bit. Has been fix with some stuf. How often and how long will it hold til I have to buy a new one? I fixed it many times Hopefully I let you know enough, I'll be waiting for your answer. Greetings, MeneerWitte What terms, I don't see any terms. It is free and no private violation? Then what terms. I still have to get a car.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has answered 20 questions.

  • Contributor
  • 144 Answers

No one can answer how long it will hold, just keep going and worry about that when the time comes.

Posted on Aug 06, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the fan control sensor located

Ron need a little bit more info as what size motor ect. Usually fan control switch is located by thermostat housing other possibilitys are a/c system is low on freon an other issues found on those models is clogged radiator or thermostat stuck closed. I would replace thermostat first make sure to fill system and purge sir out of system by sweezeing upper radiator hse untill all air has been removed. Upon starting make sure to run jeep for 15 min with heat on to allow air in heater core to be removed as well. Also make sure cooling fans come on. Your model may have either one dual speed fan or two fan motors one for motor one for a/c possible blown fuse or burnt ot relay

If you need further help, I’m available over the phone at

Jun 22, 2014 | 2005 Jeep Liberty Limited

1 Answer

How to flush coolant on 2004 grand prix

  • Move your badass w-body (a.k.a. Pontiac Grand Prix) to a level area and set the parking brake. Pop the hood and touch the radiator. If it's warm let it cool before you continue.
  • Twist the radiator cap one full turn (Remember to be careful because even when radiators are cool they can still erupt coolant)
  • Place any type of container (bucket [but has to be able to hold 2 gallons]) underneath the radiator and blow the drain plug. (The drain plug on your Grand Prix is on the driver's side bottom of the radiator facing the engine.)
  • Loosen the drain plug and let the old coolant to drain completely. (You may need a wrench to loosen the drain plug)
  • Dispose the old coolant in a sealable container (The coolant is very toxic to people and pets, so you gotta be careful)
  • Shut the radiator drain plug and fill the radiator with water.
  • Run car for a little bit and repeat the process again. (Let car cool, and drain water)
  • Close the drain plug and fill the radiator with fresh coolant until it's about an inch from overflowing. (DO NOT USE ORANGE DEX COOLANT IT IS HARMFUL FOR YOUR HEADGAKETS) You will need 3 gallons of coolant (SE, GT, GT1, GT2, GTP, GTP Comp G.) and 4 for the GXP model. Be sure to check the drain plug for any leakage.
  • Start your car and turn the heating system to high. Allow the car to keep running until the cooling fan turns on twice. After that happens, switch off the engine and check the coolant level. If it went down, add more coolant. If not, put the radiator cap back on and close the hood.

Feb 20, 2014 | Cars & Trucks

1 Answer

Door wont close all the way it causes wind noise inside the car how do i fix this??

In the door jamb, loosten the 2 star screws that hold the piece that the latch catches and move it closer to the center of the car. This will make the door close a little bit farther for the latch to engage.

Nov 18, 2010 | 2003 Pontiac Grand Am

1 Answer

4.0 litre ford motor not using any water but overheating not using oil either

I believe you have electric cooling fans which are part of your cooling system . First , remove your radiator cap and allow the engine to warm up to operating temperature . The cooling gauge needle must be close to half way. You want to make sure the thermostat is open . Slowly raise the RPM to about 1500 while watching the coolant . You should see movement of the coolant indicating the thermostat is in fact opening . Once you verify that is OK , the Nextstep is to verify that your cooling fans turn on . Put the radiator cap back on and continue to hold the engine RPM at about 1500 . As the needle on the gauge moves to the center or a little bit higher , the cooling fans should start up . If the needle continues to climb towards the red zone but the fans don't come on , your problem will be in the cooling fan circuit . I suggest having a professional diagnosis be done .

Nov 18, 2010 | Ford Aspire Cars & Trucks

1 Answer

I have a MBC220 94 and the oil go to the radiator.what is the problem and the solution?

If there is oil in the radiator, the problem lies in the headgasket. The gasket is broken in certain areas. Try a product carried in a lot of auto parts stores for around $20 called Liquid Glass. This is a permanant fix and will eliminate the need for headhasket replacement. Follow the instructions on the bottle and when you are done, purcahse a chemical radiator flush to rid the cooling system of the oil which will rot any of the hoses and the heater circuit waterpump til they fail. Once that is flushed and the system is filled with good clean coolant mixed with distilled water, turn the heater on high and make sure that the temperature om the gauge does not get above 80 celsius and that the fan is working. Let me know.

Nov 08, 2010 | Mercedes-Benz C-Class Cars & Trucks

2 Answers

Would like 2 know how 2 bleed my coolant system

there should be a bleed nipple at the highest point of the water jacket
somwhere around the head

Apr 09, 2010 | 1995 Honda Accord

1 Answer

The radiator on my 1998 Honda CRV is loose. What

If you have about 1/8" of slop that is normal. If it is worse than that do you have the rubber spacers on the top posts of the radiator that go in the holes of the radiator mounting brackets. If you need to you can remove your mounting brackets and bend them down a bit to add tension. This will calm some of the slop down; you want it to move a little bit as the vehicle flexes and hits bumps. A fully stiff radiator will soon be a broken radiator.

Dec 28, 2009 | 1998 Honda CR-V

2 Answers

Do I need to bleed the system after replacing the radiator cap?

Definitely recommended - Process is fairly simple, let the vehicle idle and/or reach normal operating temperature - turn the"bleed screw" slightly open and note as the air bubbles escapes from the screw. Also make sure the radiator is topped up with sufficient coolant. Funny enough, the mechanic should have taken care of this process after replacing the thermostat....

Jul 16, 2009 | 2000 Jeep Grand Cherokee

1 Answer

1995 Z28 overheating and loosing power

It sounds like your cooling system is becoming clogged with debris. Flush your radiator, replace the temperature sensor and the thermostat. Also, Griffin makes great after market high capacity aluminum radiators, a little pricey, but worth the money the event you have to replace the radiator due leaks and corrosion.


Oct 11, 2008 | 1995 Chevrolet Camaro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides