Question about 1992 Chevrolet Corvette

1 Answer

Need to replace the 02 sensor on my 1992 chevrolet corvette, I have the sensor but trying to figure out where it goes underneath the car??

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chevrolet Master
  • 540 Answers

There should be more than one 02 sensor so make sure to replace the correct one, but anyways they screw into the exhaust pipe usually near where the pipe meets the exhaust manifold

Posted on Aug 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why doesnt my 1992 corvette start and has no spark or fuel?


Coil? Coil wire connected? Fusing. or the opti was installed incorrectly. Did it run prior to repair?

May 18, 2014 | 1992 Chevrolet Corvette C4

1 Answer

Locate 02 sensor


On the I6 engine, the precat sensor is located on the passenger side of the engine right below the exhaust manifold. Easty to get to, unplug the sensor and use an 02 sensor socket to remove. Post cat sensor is underneath after the cat. The connector to unplug is located in a difficult position, near the top of the transmission. I find that moving yourself toward the rear of the car and reach in the easiest. As opposed to reaching in right above the 02 sensor.

May 13, 2014 | 2003 Chevrolet TrailBlazer

1 Answer

Interrupter switch replacement


if its a oil pressre sensor it most likely goes on or somewhere around your oil pan close to your starter

Feb 11, 2013 | 1992 Chevrolet Lumina

1 Answer

Haloo .. i have corvette cat 1992 , i got in side monitor a red light it calls ( infl rest ) , what does it mean and how to fix it ? thank u .


Inflatable Restraint Light on means there is something wrong with your Airbag System, either a sensor or component and you should take your vehicle to a qualified repair shop to have it diagnosed.

May 05, 2011 | 1992 Chevrolet Corvette

1 Answer

Has dead spot when you first take off. Seems like it wants to stall for a second. (LT-1) 1992 Corvette.


TEST THE THROTTLE POSITION SENSOR AND MAKE SURE THE THROTTLE BODY IS CLEAN..

Jan 10, 2011 | 1992 Chevrolet Corvette

1 Answer

Antenna goes up not down 91 crovette


Sounds like you need "91 Corvette power antenna mast and cable" I replaced mine 4 years ago for 34.00 on Ebay. you might do a search on CORVETTE Power Antenna MAST 1988-1992 + How 2


They have it for $21.99 + $5.00 shipping. Or just search on ANTENNA MAST, there are 2,700 matches for this search.


necss03

Oct 16, 2010 | 1991 Chevrolet Corvette

1 Answer

1992 Corvette headlight repair/ replacement Light opens, willnot close.


Do you hear a clicking noise as if it is trying to close? If so, it may be the gear located in the h/light motor housing that needs replacing. You can purchase these for anywhere from 24.99 - 65.00 each, online. Hope this helped.

Aug 03, 2010 | 1992 Chevrolet Corvette

1 Answer

1992 corvette my gas gauge stays on full it was working i filled the car up stays on full now


Sounds like the float is stuck on the sensor in the tank.You could try takeing a rubber mallet when the tank is near empty and rap on the under side or any where you have access.If this doesn't work you may have to drop the tank and replace the level sensor.Well good luck and hope this helps.

Mar 25, 2010 | 1992 Chevrolet Corvette

1 Answer

Took off TPS? to clean up. Replaced with new gasket now motor will turn over but not start. Have spark, no fuel. 1992 vette. Do I need to reset computer? Unplugged IAC and MaF and tried to start. No go....


could have damaged the tps. if the tps shorts out and shows like its full throttle, it goes into clear flood mode and shuts down the injectors. try unplugging the tps and try to start. it it starts, replace the tps.

Jan 25, 2010 | 1992 Chevrolet Corvette

1 Answer

Do I need a mechanic for routine maintenance, change oil, plugs..


very easy job, just locate the sump bolt underneath the engine and drain, plugs are just as simple

May 03, 2009 | 1992 Chevrolet Corvette

Not finding what you are looking for?
1992 Chevrolet Corvette Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...