Question about 2001 Chrysler Sebring

2 Answers

Need to know location of thermostate on 2.7 engine

Posted by on


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chrysler Master
  • 17,970 Answers

2.7L Engine

  1. Disconnect negative cable from remote jumper terminal.
  2. Drain cooling system.
  3. Raise and safely support the vehicle.
  4. Remove the right front wheel and belt splash shield.
  5. Remove the accessory drive belts.
  6. Remove the lower alternator mounting bolt.
  7. Lower vehicle.
  8. Disconnect alternator electrical connectors.
  9. Disconnect AC clutch and AC pressure sensor electrical connectors. Reposition wiring harness.
  10. Remove the oil dipstick and tube. Plug hole in oil pan where dipstick tube mounts with water tight stopper.
    NOTE If hole for dipstick tube in oil pan is not plugged, coolant will enter oil pan. Serious engine damage can occur.
  11. Remove the remaining alternator mounting bolts. Remove alternator.
  12. Disconnect hoses at thermostat housing.
  13. Remove the thermostat housing bolts.
  14. Remove the thermostat and housing.

need to know location of thermostate on 2.7 engine - 7a7208b.jpg

Fig. Air bleed valve (1) and thermostat housing (2) 2.7L-engine

Hope helps (remember rated and comment this).

Posted on Aug 06, 2010

  • Level 1:

    An expert who has achieved level 1.


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has answered 20 questions.

  • Contributor
  • 144 Answers

It is connected to the cylinder head. Follow the top hose of the radiator and you will see it.

Posted on Aug 06, 2010


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 2761 Answers

SOURCE: location of thermostate on engine

You're going to lose some coolant, so have a bucket or other container ready. Follow the upper radiator hose to the point where it's connected to the engine. The hose is clamped to a metal housing which is bolted to the engine. Remove the bolts (not the hose) and lift the housing to expose the thermostat (may require a little prying with a screwdriver or similar tool). Note how the old thermostat is fitted (which end is up), lift it out of the engine, and then remove all traces of gasket from the housing and the engine. Install the new thermostat and gasket, replace the bolts, add coolant as necessary, and you're done.

Posted on Jan 04, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do you find the thermostate located at on engin?

You need to follow the top radiator hose down to the thermostat housing. If will either 2 or 3 bolts in it and be domed shape.

Jun 18, 2014 | 2005 Chevrolet Monte Carlo

1 Answer

Need to locate and replace the water pump on 1997 nissan sentra.

The water pump is located on the passanger side of the engine. Look right below the timing chain cover and there is a pully and belt on the water pump. You will have to remove the water pump and thermostate together then seperate them after you get them off the car. I would recommend replacing the thermostate also (cheap fix). You will have to remove the belt and pully before you can remove the water pump. Hope this helps....

Jan 05, 2013 | 1997 Nissan Sentra

1 Answer


find top of coolant fill find hose closest to it follow hose over to engine there under cast metal connection to engine there is thermostat

Oct 04, 2012 | 1995 Ford Aerostar

1 Answer

I need to know exactly where the location of the thermostate is in my 1994 mazda MPV. Can anyone help me? I am trying to change it.

Follow the lower coolant line from the radiator to the engine and the thermostat will be under that housing. Hope that helps you.

Aug 05, 2011 | Mazda MPV Cars & Trucks

1 Answer

I need to replace my thermostat and don't know how

follow the top radiator hose to the engine....your thermostate is located at the end of hose...take that end of hose off and thermostate is screwed into engine unscrew and take out .

Jan 06, 2010 | 1998 Chevrolet S-10 Pickup

1 Answer

Can't locate thermostate

The drivers side of the engine block behind the alternator. It is not necessary to remove the alternator to replace the thermostat. You will have to remove the ecm.

Oct 02, 2009 | 2005 Chevrolet Trailblazer Ext

1 Answer

I need to know where the thermostate is located on my 2001 camry CE 4 cylinder

go to top radiator hose follow it to the engine, where that hose connects to the engine is the thermostat housing undo the bolts that hold dome shaped housing in place and hey presto there it is.take note which way it comes out,when reinstalling use anew gasket___DONT runthe engine with out one for any length of time good luck

Jul 31, 2009 | 2001 Toyota Camry

1 Answer

Thermostate location

on the drivers side of engine below the water pump drive belt the upper rad hose is attached to the housing that it is in

May 27, 2009 | 2000 Cadillac DeVille

1 Answer

How many thermostats does a nissan altima have and were and how

You have one and you can locate it by following the tope radiator hose to the engine. The housing that the hose is connected to the engine is called the thrmostate houseing and the thremostate is located in it. 
Remove the hose and the two bolts holding the housing down to access the thermostate. Clean the two serfice before reinsatlling the new thermostate and replace the gaskit if needed. 
Just dubble check with the procedures and any additional parts, at the parts store. Ther have all the how to do it your self for any repairs needed to be done. 
Good luck and hope this helps.

Apr 20, 2009 | 2003 Nissan Altima

1 Answer

Where to find the thermostate on 2001 stratus

If it's not up top it's behind the lower hose. I know it's behind the lower on the 2.7 litre motors.

Dec 01, 2008 | 2004 Dodge Stratus

Not finding what you are looking for?
2001 Chrysler Sebring Logo

329 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

81423 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides