Lost remot control how to have a new remot control ?

I disagree. If you have a key that starts the car then the immobilisor is good. A new remote can be easily programmed, and a new key can too.

You set the frequency to the same freq. as your alarm on the vehicle by entering your code number

A universal remote will work if you can find one that will control that brand of reciever,

Cheapest alternative to purchase a "new" remote key fob is on eBay. Search for "remote key fob, 2004 Trailblazer". Check and/or inquire about programing instructions.

Why not just get the factory PATS System working correctly. You can't remove the factory system,it's an integral part of you vehicles systems and processors

You can get new remotes and program them!!

Synchronization
When
System malfunction. Remote control added or replaced.
How
Access alarm system control module located under driver's side lower fascia Fig. 2 . Set memory switch to SET position. Press remote control lock or unlock button. Set memory switch to OFF position. Confirm synchronization has been successful by locking and unlocking vehicle. Repeat procedure for second remote control. Synchronization can also be carried out using diagnostic equipment.
NOTE: A maximum of 2 remote controls can be programmed. NOTE: If remote control fails, system can be deactivated as detailed in the owner's handbook. Fig. 2

programing a Nissan remote , is hidden secret by Nissan Dealers. As a Nissan Technician i will share it.

Just get in your vech , close all doors. Using your power lock switch , lock all doors. After doors are locked take your Ignition Key and insert it and remove it from ignition switch in a slow fashion , but consitant pace. (97 and earlyer are fast) When you see the hazzard lights flash, put key in ignition switch and turn to the On postion .. Do NOT CRANK or you will have to Start over .. After in the On postion .. Hit the Lock button on remote... Hazzard lights should flash..( note..you have to reprogram all remotes when adding a new one , if you don't your old remotes will not work ) If your doing just the one , turn igntion switch off and unlock door and get out and try it. If you are doing more than one. While still in Vech with Key on . After you hit the Lock button on Remote and hazzard light flashed .. with key still on .. use master lock switch unlock doors and relock and then hit Second Remote, Lights should flash again , repeat if adding a 3rd remote.. after done just turn key off and unlock door and get out and try.

You will need to change even the remote engine as well.

It can be gotten on http://www.ebay.com

Cheap too.

Cheers and remember to rate this.

remote control codes for dvd player

The nearest VW dealership is in Israel or you can try VW website for your area.