Question about 1998 Jeep Grand Cherokee

1 Answer

Blower only works on high, where EXACTLY is the blower motor resistor located?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

These components are conveniently located behind the glove box.

Please rate this solution, thank you.

Posted on Aug 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My heater blowers dnt work and i need to knw where i can locate the resister blocks for my heater blowers so i can ghange them


Its located under dash,or near glove box.

The dash panel lower side has to be out.

HEATER BLOWER MOTOR


Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.


It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.


=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

Nov 28, 2012 | Cars & Trucks

2 Answers

Location of the resister for the heater fan 350 ford 2006


Its under dash panel.

HEATER BLOWER MOTOR


Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.


It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.


=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

Nov 28, 2012 | Ford F-350 Cars & Trucks

1 Answer

Blower motor only works on high


This is a problem that is due in every case to a failed blower motor speed control resistor. the blower motor resistor is located right next to the blower motor and the wiring harness connector sticks out of the air ducting that cools it.

Sep 27, 2012 | 2006 Mitsubishi Galant

1 Answer

93 nissan maxima heater blower motor works on high only


You have a defective heater blower resistor, the part is located next to the blower motor in the air ducting that it uses to cool the resistor.

Aug 24, 2012 | Cars & Trucks

2 Answers

01 grand.prix ac fan switch only works on high. has a duel temp controller when you turn fan off the only way fan comes back on is to move the temp controller levers


Hi!!
When the Blower Motor Resistor (controls blower speeds) goes bad, the blower motor works only on HIGH SPEED. REPLACE IT.
BLOWER MOTOR RESISTOR Removal & Installation
  • Disconnect negative battery cable.
  • Remove right lower instrument panel insulator panel.
  • Disconnect blower resistor connector located behind right side of dash.
  • Remove blower resistor screws and blower resistor.
To install, reverse removal procedure
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa!!

Feb 18, 2011 | 2001 Pontiac Grand Prix

1 Answer

Trying to locate where the heater relay that hooks to the blower motor is located


It is mounted on the fire wall in a block of two or three relays depending on what equiptiment is standand in your vehicle.Its toword the left side near the ACand the blower motor units Like i said it depends on what you have some are intergrated into the motor . But if you have splice # S108 the goses to the relay and splits and goes to blower motor resistor unit then its the one on the far right hand side of the block. There all interchangable and work exactly the same. However the blower motor relay directs bat voltage to the blower motor olny at blower high speed setting.The blower motor resistors direct battery voltage at all other speed settings. S o in a nut shell if it works on high the relay is good and its the resistors or a connection issue. Try the connections first thats the most likely problem if you olny have high speed

Jan 21, 2011 | 1999 GMC Yukon

3 Answers

I only get the fan to work on high speed, the lower speeds do not work


Hi!!
The Blower Motor Resistor also called Manual Temp. Control resistor), is fried, replace. The price with floor console $25 and without floor console $65. here is a pic.
87b9810.jpg

the resistor is located on the blower motor housing, fastened by two screws. It is the part where the electrical plug connects, the plug on the pic. goes to the blower motor.
A HELPFUL - 4 THUMBS rating for this solution would be greatly appreciated. Thank you for using FixYa.

Oct 19, 2010 | GMC Yukon Denali Cars & Trucks

2 Answers

Ac blower motor


it should be located in the heater/evap case under the dash by the glove box, usually the pigtail from the blower motor itself leads the the resistor pack.

May 29, 2009 | 2006 Chevrolet HHR

1 Answer

2005 Kia Sorento only blows hot and cold air on high. Is it a blower motor resistor and if it is where is it located?


If the blower moter only works on hi speed it is the blower motor resistor that is bad. The blower motor resistor is located under the passenger side of the dash next to the blower motor. It is not necessary to remove the blower motor to change the resistor.

May 12, 2009 | 2005 Kia Sorento

2 Answers

Fan motor on 2000 Caravan works only on high.


For the problem of the blower motor only working on high, I just replaced my blower motor resistor. It is located under the hood on the firewall on the passenger side. There is a rectangular plug that connects to it. Remove the plug (tight space). The resistor can be pryed out. It is just held in with retaining clips. Insert the new part (about $15) and reconnect the plug.

Took about 20 minutes. Blower now works on all speeds as normal.

Good Luck!

Oct 01, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
1998 Jeep Grand Cherokee Logo

345 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...