Question about 1987 Chevrolet Camaro

1 Answer

Sparking on cables - 1987 Chevrolet Camaro

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,092 Answers

If the spark plug cable's are lighting up like a light show, the spark plug cable's will have to be replace, the insulation on the cable's has worn out, will make your engine run with a cylinder miss, and wast gas.

Posted on Aug 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the ground wires on my car


If you are talking about the cables sparking when you connect or disconnect them then yes that is normal.

Aug 27, 2015 | 2000 Volvo V40

1 Answer

I have a wv microbus 2.3i 1998,it just went of while i'm at a speed of 120km/h since than it doesn't want to start.the coil is get current its not sparking,what might be the...


Dear Sir,
As you said coil is getting currant but not sparking further to spark plug , then check few things.

1 Check the connector is proper fitted on ignition coil.

2. No lose connection with pin of connector or pin should not be lose.

3. All pins are clean of connector and no rust is there.

4. Check High Tension cable (cablle black couler which run from ignition coil to spark plug) if found ok then try with new cable if it wont start.

5. It is problem with ignition coil replace it problem will solve.

Problem can solve at any step from 1 to 5 i did arrange all steps by easy to check and less expanses, final step will more expansive than earlier step.if any issue let me know. thanks

Yogesh

Nov 16, 2010 | 2005 Volkswagen Microbus

1 Answer

Replaced a starter went to hook battier back up and it is sparking pretty good!!!!


Make sure starter end of battery cable is not touching anything else but the mounting post on the starter. Make sure Pos is to pos and neg is to neg

Aug 10, 2010 | 1997 Dodge Neon

1 Answer

My 1995 Toyota Camry is sparking at the distributor at the #4 plug while it s running feels like it wants to turn off but it doesn't.


If this is sparking out of what appears to be unexposed (covered) portions of the spark plug wire replace the wires. It might also be a good time to change the ignition cap and rotor as well. It may be "sparking" out of more places than you know. To test this start the car and watch the under hood in the dark or very low light.

Jan 19, 2010 | 1995 Toyota Camry

1 Answer

Instructions for replacing the battery in my 2006 Chevy Equinox


take the support bracket that holds battery secure off unloose your cables and twist them while pulling them up. you may need to leave the bracket on then once the cables are loose take the bracket off make sure when you install your new battery that once you put one cable on make sure that the free cable touches nothing metal and also when putting on the last cable try to keep sparking to a minimum.

Oct 03, 2009 | 2006 Chevrolet Equinox

1 Answer

A fuse has been blown when connecting battery cables negative to negative and positive to positive


sometimes it happens because of sparking, replace the fuse with new one

Aug 03, 2009 | 1994 Honda Accord

1 Answer

2000 saab 9 5 wires by what i think is the starter sparking and smoking. area below manifold and has a large wire from battery


Poor connection, bad cable & or faulty starter. Remove battery cables at battery & check for tight, good connection at starter, & tighten if necessary, or replace cable if worn out or damaged, then reconnect battery & try it. Spray penetrating lube on nuts before trying to loosen or tighten. Is there a heat shield missing that should be protecting that area by chance?

Jul 08, 2009 | 2008 Saab 9-5

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...