Question about 1992 Mazda MX-3

1 Answer

Replace the thermostat on my 1992 mazda mx3 now it wont start

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,092 Answers

If it was running before you replace the thermostat, check for ground wire's in the area you were working at, very important on imports.Other will still run, not imports.

Posted on Aug 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mazda MX3 "Charge" light


You can use VCM IDS for Mazda to have a check

Jul 19, 2013 | 1992 Mazda MX-3

2 Answers

I have a 1992 mazda mx3 was driveing and it died like it was out


The easiest way to rule out a fuel starvation problem is to remove the rubber air tube between the throttle body and the air box, manually open the throttle body valve and spray a short burst of stating fluid into it. Quickly release the valve, and attempt to start the car. If it starts and runs briefly then you are not getting fuel.

Jul 20, 2010 | 1992 Mazda MX-3

1 Answer

1992 mazda mx3 heater blows warm, but not hot. Coolant is full, heater hoses are hot. What is wrong?


Hot air is dependent on the coolant temperature and the heater core. There are several things that can cause your problem. The easiest to check is the coolant level in the radiator\reservoir. There must be enough coolant to flow freely between the engine and the heater core. The next is the thermostat. If the thermostat is not closing it would prevent the the coolant from reaching a high enough temperature to allow for hot air. The thermostat is not expensive or difficult to replace. The third thing is a blockage in the heater core. Flush the coolant system properly can sometimes take care of this. If it does not the only alternative is a new heater core.
Hope this helps.

Sep 12, 2009 | 1992 Mazda MX-3

2 Answers

1992 mazda mx3 heater blows warm, not hot


If it ran out of water and you filled it up just before the problem started then their may be air in the system so will need bleading. If that's not the problem then could be a sticking thermostat. Vheck these first and let me know if you need further help I can advise further. Cheer's

Sep 12, 2009 | 1992 Mazda MX-3

1 Answer

I have a 1992 mazda mx3 it starts but it dies. What causes this


check the fuel filter and the hi tension wire and the distribution cap and also the battery terminal make sure it is fix and check the battery if still in good shape.

Jun 09, 2009 | 1992 Mazda MX-3

1 Answer

92 mazda mx3 will crank but will not start but


i dowt it did u check the iac valve stands for idle air control valve or possibly ect sensor

May 19, 2009 | 1992 Mazda MX-3

1 Answer

Mazda mx3 wont start


VSS or vehicle speed sensor aka cam sensor or crank position sensor. Test the battery and alternator. You should also check for blown fuses, bad wires and grounds on a car as old as yours. If you find it's getting spark and fuel after further testing, check the timing belt. It could have slipped or broke even if it was changed recently so either pull off the cover or at least do a compression test.

Apr 16, 2009 | 1992 Mazda MX-3

1 Answer

I need to know if a 1992 mazda mx3 1.8l v6 is compatible with a 1996 mazda mx3 1.6l for the suspention and other componants?


nope diffrent trans man not to mention obd1 for 92 obd2 for 96 lots of work man not somthing i would call easy

Mar 26, 2009 | 1992 Mazda MX-3

1 Answer

Mx3 idle


your throttle body is dirty and needs to be cleaned- also, you might want to check the spring and the various parts on the throttle itself for wear and tear.

the intake for air and the flutter wing could also be hanging up inside the air intake

Jan 02, 2009 | 1992 Mazda MX-3

Not finding what you are looking for?
1992 Mazda MX-3 Logo

Related Topics:

258 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...