Question about 2006 Chevrolet Silverado 1500 2WD

Open Question

I have a 2006 Chevy Silverado, 4.8L V8. My truck sounds like it wants to turn over but won't. I ran a scan on it and got a few codes. Here are the codes: P1516, P2101, P2108, U0107. Can you help?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 24 Answers

SOURCE: 2004 A 8L won"t start

starter wont click because there's not enough "juice" to turn it over. this isnt because of the battery as you have just replaced it. it is due to a bad alternator recharging the battery as you drive. if it were only a fuse it would be the solenoid in the starter. but if it had started after you installed the battery then its not the solenoid. solution: buy a refurbished alternator and

Posted on Apr 24, 2009

Ad
  • 31 Answers

SOURCE: 2005 chevy silverado won;t start.

i had the same problem, and it turned out the coil pack was moulding inside wich stopped the spark all together, i ended up changing my coil pack and putting on new wires because the ends connected to the coil were very corroded and that cures the not running part just fine


enjoy

Posted on Jul 01, 2009

dvs9mm1971
  • 114 Answers

SOURCE: reduced power p1516 code

P1516 Throttle Actuator Control(TAC) Module Throttle Actuator Position Performance

This is your problem and should be taken in to chevy for repair

Posted on Oct 15, 2009

  • 1608 Answers

SOURCE: 2006 5.3ltr chevy silverado z71 p0455 andp0449

These codes are for the evaporative emission system.The 455 is the vent solenoid.The 455 is a large leak in the evap.system.The vent solenoid I would replace because they go bad and will not work because they are under the vehicle in the rear of the truck.There is a bulletin for these and the vent valve is installed in another spot.The number for the bulletin is 02-06-04-037E.You should also look for a broken or loose hose or pipe that might have came off.Specially if you ran over something.If none found it could just be the vent solenoid stuck in the venting position.Good luck.

Posted on Dec 01, 2009

Ninja_Rick
  • 119 Answers

SOURCE: 2006 chevy silverado 1500 the trucks fell

take it to the dealer if it's waranteed

Posted on Feb 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

06 Chevy Silverado code p0053 and p0135


DTC P0053 HO2S Heater Resistance Bank 1 Sensor 1
• DTC P0135 HO2S Heater Performance Bank 1 Sensor 1
Important: Whenever the heated oxygen sensor (HO2S) heaters are commanded ON with a scan tool, they will continue to be pulsed ON once per second until the ignition is turned OFF for 30 seconds.
Turn ON the ignition, with the engine OFF.
Command the HO2S heaters ON with a scan tool.
Wait 15 seconds to allow the HO2S heater current to stabilize.
Observe the affected HO2S Heater Current parameter with a scan tool.
Is the HO2S Heater Current parameter within the specified range?
0.25-1.375 A

Sep 10, 2016 | 2006 Chevrolet Silverado

1 Answer

My oil gauge for my 2006 Chevy silverado v8, 2wd does not work. It reads 0 pressure and stays until at a stop and radically jumps.


Sounds like you need to replace the oil pressure sending unit. Should be located on the engine down by the oil filter.

Apr 21, 2013 | Cars & Trucks

1 Answer

1996 chevy silverado v8 4.3 won't crank. Replaced


Check the voltage coming from the battery and check it again at the coil.I suspect you are not getting the proper voltage going through. Clean all the terminal ends to bare shiny metal and make sure all the connections are tight. If I remember correct your truck still has the HEI setup with the coil in the top of the distributor cap. If all the voltages are good, 12+ volts you should replace the coil. Hope this helps.

Nov 06, 2011 | 1996 Chevrolet K1500

1 Answer

I have a 2000 shevy silverado 1500 v8 5.3. THe truck is turning on then starts to idle rough and turns off.


If it is doing all of that, it should be setting fault codes in the engine control computer. The place to BEGIN diagnosis would be to scan the computer for fault codes.

Sep 11, 2011 | 2000 Chevrolet Silverado 1500

1 Answer

2006 5.3ltr chevy silverado z71 p0455 andp0449


These codes are for the evaporative emission system.The 455 is the vent solenoid.The 455 is a large leak in the evap.system.The vent solenoid I would replace because they go bad and will not work because they are under the vehicle in the rear of the truck.There is a bulletin for these and the vent valve is installed in another spot.The number for the bulletin is 02-06-04-037E.You should also look for a broken or loose hose or pipe that might have came off.Specially if you ran over something.If none found it could just be the vent solenoid stuck in the venting position.Good luck.

Nov 30, 2009 | 2006 Chevrolet Silverado 1500 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

226 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...