Question about Ford E-350

1 Answer

My motor home stop after two hours, after 20 minutes restart without problem and will run for about 40 kilometer, but if I drive at 90 mn/h will run for 70 km

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Ford Master
  • 3,854 Answers

Start with the simple and replace your fuel filter, note that a dirty fuel filter will cause your fuel pump to work harder and shorten the life of it due to the excessive heat generated.
Thank you for using fixya and keep us posted.

Posted on Aug 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car intermittantly shuts off and won't restart for an hour or two


I owned a 1988, Oldsmobile 88, that did that. after several hundred $ of "repairs" - It was that pump IN the gas tank that had gone bad.

Apr 27, 2017 | 1999 Ford Taurus

1 Answer

Need torque specs for a head on a 1997 bmw 528i with a 2.8l


(29.5 lbs)40 nm and wait 20 minutes and turn 90 degree wait for 20 minutes and turn additional 90 degree for "IRON BLOCK" . "Alumn. Block" is (22.1 lbs) 30 nm wait 20 minutes and turn 90 degree, wait 20 minutes then turn additional 90 degree. DONE!

Sep 10, 2012 | Cars & Trucks

1 Answer

The engine on my 2000 MPV cuts out and dies when I press the accelerator. After it sits for an hour or so, I can travel for 20 min. or so before the problem starts again. HELP!


if its been a while change the fuel filter and then have the fuel pressure and volume checked.these symptoms are very common for a fuel pump problem.

Feb 07, 2012 | 2000 Mazda MPV

2 Answers

Not Ready for Smog test


it is not how many miles but the type of driving.

here is a OBD2 drive cycle test.

Generic OBD II "Drive Cycle" Most OBD II ("On-Board Diagnostics II") diagnostic monitors will run at some time during normal operation of the vehicle.
However, to satisy all of the different Trip enable criteria and run all of the OBD II diagnostic monitors, the vehicle must be driven under a variety of conditions. The following drive cycle will (theoretically) allow all monitors to run on (??) vehicle. (Note: Drive cycle specifics vary by vehicle!)
  1. Ensure that the fuel tank is between 1/4 and 3/4 full.
  2. Start cold (below 86°F /30°C) and warm up until engine coolant temperature is at least 160° F (typically requires at least one minute; up to 3 minutes).
  3. Accelerate to 40-55 MPH at 25% throttle and maintain speed for five minutes.
  4. Decelerate without using the brake (coast down) to 20 MPH or less, then stop the vehicle. Allow the engine to idle for 10 seconds, turn the key off, and wait one minute.
  5. Restart and accelerate to 40-55 MPH at 25% throttle and maintain speed for two minutes.
  6. Decelerate with using the brake [or the clutch!] by coasting down to 20 MPH or less, then stop the vehicle. Allow the engine to idle for 10 seconds, turn the key off, and wait one minute.

Jun 04, 2010 | 2001 Kia Sephia

1 Answer

Intermittent shut down of Jaguar XJR while running


The fault is intermittent - strikes without warning - and I guess if there are no error codes - so the fault is beyond the reach of the computer sensors - change your high tension coil.

May 27, 2010 | 1995 Jaguar XJ-R

1 Answer

Motor spuders at highway speed, sometimes


is check eng light on, poss engine miss go to auto zone pull codes

Aug 23, 2009 | 2002 Pontiac Montana

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...