Question about 1993 Ford Explorer Limited

Open Question

When I scan my Ford explorer 1994 describe code 341 (O) octane adjjus service pin open. The car is runing and all of a sudden after 2o min. of runnig it starts shaking , looses force and it turns of, It will not turn back on until it totaly cools down. But any time it shows is over heated. It feels like it looses electicity.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 92 Answers

SOURCE: 2001 ford focus

the cooling fan will always come on when using the a/c,so it is not a fan problem,sounds like the pcm is not getting a signal to turn cooling fan on,could be coolant temp sensor.

Posted on Nov 01, 2008

Ad
chrischronic
  • 235 Answers

SOURCE: window stuck down on 1994 ford explorer

while holding the switch in the up position, bang on the middle part of the door panel, if the motor is stuck then this will usually unstick it. but if motor is running then you will need a new window regulator.

Posted on Jan 22, 2009

  • 33 Answers

SOURCE: when I start my 1999 ford explorer the oil presure gage does not

The oil pressure switch is a common problem on this vehical. Replace it.
It's located right by the oil filter. you will have to reach it from underneath the truck

Posted on Feb 13, 2009

  • 1118 Answers

SOURCE: car drives like new until about 20 min of driving

Try changing your fuel filter. And take a fuel pressure test.

Posted on Mar 14, 2009

  • 130 Answers

SOURCE: 1998 Ford Explorer will not start when hot

Sounds like the choke is getting stuck. It's an electric choke. So, clean it and its linkages. Also, check the vacuum for leaks. With 123K, I'd start with a cleaning.

Posted on May 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ive got a 93 ford ranger.after it gets warm & u cut it off for about 5 mins,& start it back its like it floods


Ford Check Engine light Codes - FreeAutoMechanic

www.freeautomechanic.com/diagnostictroblecodes7.html
Full list of OBD I Diagnostic Trouble Codes for your Ford Vehicle. If your Check engine light is on you may have a serious problem. Scan your codes and follow ...

EEC-IV 2 and 3 digit trouble codes. - Ford Explorer and Ranger ...

www.explorerforum.com > ... > EEC IV
Feb 6, 2007 - Serious Explorations Ford Explorer and Ranger Message Board .... 3.8L AXOD - Message center data link circuit fault - See code 70 73 (O) Is FORD DEALER the only place who can read out ABS error ...
Dec 5, 2011
Error codes 186 & 539.
Aug 15, 2009
OBD-II Diagnostic Trouble Codes (DTCs)
Nov 8, 2008
Have a Code? OBD II Trouble Codes Here
Jan 19, 2006
More results from www.explorerforum.com

EEC-IV Diagnostic Trouble Codes - Diagnose problems in


Dec 19, 2015 | 1988 Ford Ranger

1 Answer

Replace ignition lock cylinder on 1994 ford explorer


There should be a hole and a pin but the ignition has to be ON to be able to open the area where the pin is

Nov 17, 2013 | 1994 Ford Explorer Limited

1 Answer

1994 S10 miss


Could be solved, then, though I've run 85 octane when it called for 88 minimum, and no problems.
Any trouble codes?

Nov 30, 2011 | Cars & Trucks

2 Answers

Describe your 1996 Ford Explorer Problem..trouble


Diagnostic Trouble Code (DTC) P0443 indicates a failure in the EVAP canister purge valve circuit.
Possible causes:
  • VPWR circuit open.
  • EVAP canister purge valve circuit open.
  • EVAP canister purge valve circuit shorted to PWR GND.
  • EVAP canister purge valve circuit shorted to VPWR.
  • Damaged EVAP canister purge valve.
  • Damaged PCM.

Jul 10, 2009 | 1996 Ford Explorer

1 Answer

1994 ford explorer exhaust smell in cabin


Sounds like an exhaust leak either at manifold or collector pipe. Exhaust is being sucked in through fresh air intake for hvac system. Must scan to determine what code is setting check engine light.

Mar 22, 2009 | 1994 Ford Explorer Limited

1 Answer

Low oil compression


if the needle is on or around the letter N then thats normal. you can also change the oil sending unit. as far as the engine light once you change the EGR valve and the EPT sensor the engine light should go off

Jan 01, 2009 | 1994 Ford Explorer Limited

1 Answer

1994 ford explorer eddie


the transmission is loseing internal fluid pressure, its time for a rebuilt transmission. The A4ld that your explorer has is prone to trouble in this area. A good rebuilt transmission may cost at least $1700 dollars.

Dec 15, 2008 | 1994 Ford Explorer Limited

Not finding what you are looking for?
1993 Ford Explorer Limited Logo

Related Topics:

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...